Turnigy Turbo Raven 30-35CC Operation instructions

CAUTION : this plane is not a toy!
Before use , please carefully read this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
Engine:30-35CC GAS;
Length:72.8in/1850mm;
performance to full extent .
Radio:6channels 6servos;
Flying Weight:5200-5500g;
Wing Span:74.8in/1900mm;
Wing Area:68sq.dm;
P1

Connect the aileron and main
wing with horns.
Cut away covering film for
the servo.
Install Servo Arms
MAIN WINGS
P2

Find out the holes in
each sides of fuselage,
then remove the covering.
Connect the main wings and
the fuselage with joiner.
Also pull the extension
into the fuselage.
Fixup the wings with plastic
bolts on both sides.
Plastic
bolt
P3

Gather the wheels,axles and
collars as shown.
Permanently tighten the axle
to the gear strut by wrenches.
MAIN LANDING GEAR
Carbon
Fiber
Landing
gear
Wheel
Pants
P4

Install wheel pants with two
mounting bolts.
Install the main landing gear
on the bottom of the fuselage.
Pay attention to:we have CB and AL landing gear for choice.
Find out the holes on each
sides of tail fuselage.
Insert the stabilizer into
the prepared hole.
Measure the right position
and remove the film from the
stabilizer.
ELEVATOR AND RUDDER
P5

Elevator assemblies.
Install elevator servos on
each sides of tailplane.
Elevator pushrod.
Rudder assemblies.
P6

Rudder pushrod.
●Ensure the servo doesn't bind
at center or at either end point.
Drill holes in the hardwood tail
wheel mount and install the blind
nut through the opening in the
rear of the fuse.
Install the mounting screw for the
tail wheel.
●Ensure it has been totally
screwed into the blind nuts.
TAIL WHEEL
Rudder
servo arm
Push
rods
P7

Install the tailwheel as shown.
Install the hatch over the opening in
the rear of the stabilizer with 4 screws.
Install the DLE 30CC as shown.
ENGINE
P8

Install the trottle servo
as shown.
Fuel pipe
FUEL TANK
P9

Place the hatch.
Use two screws to secure
it firmly.
Mounting the cowling by
wood screws.
COWLING
P10

CG POSITION & CONTROL THROWS
P11

P12

P13

P14

P15

to the gear strut by wrenches.
P16

on the bottom of the fuselage.
P17

P18

P19

the rear of the stabilizer with 4 screws.
Install the DLE 30CC as shown.
P20