Turnigy Super Cub 60 User manual

CAUTION : this plane is not a toy!
Before use , please carefully read this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
performance to full extent .
Engine:2C-60 or 4C-91;
Radio:4Channels 5Servos;
Flying Weight:3400g; Wing Span:80.7in/2050mm;
Wing Area:64sq.dm;
Length:57.1in/1450mm;
P1

Cut away covering film for
the servo.
Install the servo to the
servo cover.
Put the servo cover in the
right position,then fixup it.
MAIN WINGS
P2

Install the servo cover to
the bottom of the wings,and
Assemble aileron、servo arm
and pushrod.
P3

Insert the main wings with
joiner,then screw them by
nylon screws.
Assemble the plastic cover
by screws on the top of the
wings.
Install the wing supports
with screws.
Make sure they are in right
positions.
6MM Nylon Screws
P4

Cut off the film for the
vertical fin.
Insert the vertical fin and
glue the rudder to the
vertical fin .
Install the tail wheel as
shown.
TAIL WHEEL
P5

Cut off the film for elevator
servo installation.
Install the elevator servo.
Fixup the adjustable tri-horn
then link the servo and
tri-horn with pushrod.
RUDDER AND ELEVATOR
Adjustable
Tri-horns
P6

Install the elevator servo.
Fixup the adjustable tri-horn
then link the servo and
tri-horn with pushrod.
Gather the 2 stroke 60 size
and 4 stroke 91 size engines
engine mount,screws as shown.
Install the 4 stroke 91 size
engine as shown.
ENGINE
P7

Install the 2 stroke 60 size
engine as shown.
Install the throttle servo
as shown.
Assemble the fuel tank in
the right position.
THROTTLE SERVO
P8

Assemble the switch as shown.
Assemble the receiver and
receiver battery as shown.
Install two wheels to the
undercarriage as shown.
UNDERCARRIAGE
P9

Install the undercarriage to
the bottom of the fuselage.
Finished photo as shown.
Install the cowling with
screws which factory provided.
COWLING
P10

CG POSITION & CONTROL THROWS
P11

FINISHED PHOTO
P12