Turnigy Sbach 342 EP 39" User manual

Wing Span:55"/1400mm;
Wing Area:38.14sq.dm;
Length:53.4"/1357mm;
Flying Weight:1500-1700g;
Radio:4Channel 4-5Servos;
Motor:AL-5055 50*55mm.
CAUTION : this plane is not a toy and should be kept away
this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
Wing Span:39.4in/1000mm;
Flying Weight:600-650g;
Wing Area:19.41sq.dm;
Radio:4Channel 4-5Servos;
Length:38.4in/975mm;
Motor:AL-2836 28*36mm;
performance to full extent .
children under 16 years of age! Before use , please carefully read
P.1

Cut the servo holes on the
bottom of the main wings.
●Check for movement and cente
r
on the servo for the aileron to be
in a level resting position.
●Check to make sure you have
the servos in a reverse manner
so ailerons with work properly.
Connect the aileron and
the main wing by hinges.
Be sure to apply instant
type glue to both sides
of each hinges.
AILERON SERVO
P.2

Link the servo arms and
tri-horns with pushrod.
Find out the holes in each sides
of fuselage,then remove the
covering.Insert the carbon joiner
in place,then put on wings.
●Check to make sure you have
the carbon in a right length in th
e
wings.
P.3

Mounting the wings with plastic
bolts on both sides.
Find and cut the hole for
arms.
Find and cut the hole for
stabilizer assembly and
rudder servo .
Plasti
c bolt
P.4

Insert and glue the vertical fin .
Assemble the rudder servo.
Insert and glue the stabilizer.
Assemble the elevator servo.
Apply instant type glue
to both sides of each
hinges of the rudder.
P.5

Screw four TP screws to
fix up the tail wheel on
the tail of the fuselage.
As shown in picture, This is
finished for the tail wheel.
Gather the wheels,axles and
collars as shown.
MAIN LANDING GEAR
P.6

Install the main landing gear with
the bolts provided and use blind
nuts already installed and use
blue Loctite on the mounting bolt
s
●Bottom View
Install wheel pants with two
mounting bolts.
Wheel pants take a lot of abuse,
mount securely!
As shown in picture, This is
finished for the landing gear
and wheel cover,wheels.
P.7

Gather Motor,ESC, and
spare parts as shown.
Fixup the the motor before
install to the model.
Install the motor to the four
adapter and use screws to
lock motor and adapter.
THE MOTOR INSTALLED
P.8

The finished picture as shown.
Install the motor.
With Canopy Locks tacks the canopy fixed in the fuselage.
Use the TP screw and pads
to lock the cowling.
CANOPY
Assemble The Cowling
P.9

55"
39"
CG POSITION & CONTROL THROWS
P.10

FINISHED PHOTO
P.11