Turnstiles HZ-FHTS04 User manual

INSTALLATION MANUAL
FOR
HZ-FHTS04 FULL HEIGHT
TURNSTILES
Revision
Date
Description
Initials
0
2017-07-02
New template
LR
1
2018-05-12
Manual update
KN
---
---
---
---

Page 2of 8
Index
Chapter 1 –INTRODUCTION .........................................................................................................................3
1.1. Product features ................................................................................................................................3
1.2. Product specifications........................................................................................................................3
1.3. Product dimensions ...........................................................................................................................4
Chapter 2 –INSTALLATION ...........................................................................................................................7
Chapter 3 –TROUBLESHOOTING AND SUPPORT..........................................................................................8

Page 3of 8
Chapter 1 –INTRODUCTION
This manual will address dimensions and the features of the HZ-FHTS04 turnstile
while also covering the process in which this turnstile is installed.
1.1. Product features
The HZ-FHTS04 full height turnstiles have the following features:
- Material: standard 304 stainless steel, with the option of getting 316 stainless
steel.
- One lane turnstile.
- Compatible with any access control system.
1.2. Product specifications
The HZ-FHTS04 full height turnstiles have the following characteristics:
- Power requirements: 110Vac [220Vac], 250W to 500W. The full height turnstile’s
lanes are provided with different power supplies, based on country and
customer’s requirements. Check the product label before connecting to any
power supply.
- Driver motor: 24Vdc, max. 40W
- Output interface: 12Vdc
- Communication interface: RS485
- Operating temperature: -4°F to 122°F [-20°C to 50°C]
- Operating humidity: 20% to 95% RH non-condensing

Page 4of 8
1.3. Product dimensions
Top Section View
Top View

Page 5of 8
Footprint View

Page 6of 8
Front View

Page 7of 8
Chapter 2 –INSTALLATION
Before proceeding to the installation of the turnstile, unpack all components and check
to make sure the all parts from the packing slip are included, verify dimensions and conduit runs.
Use the turnstile template to properly align and lay out the site and to determine the right
location of the floor stub-ups and anchors.
Site preparation:
- Make sure that the floor is level before the installation process starts.
- When measuring the distance between the cabinets always refer to the center of
the cabinets, not the corners.
- Using the factory provided template and design layout drawings outline the exact
position of each turnstile. Make sure the floor outline includes the space
dedicated to conduit stub-ups.
- Install conduits for low voltage cables and for 110Vac (220Vac) power. Size
conduits based on the number of cables and follow local installation codes.
- On the turnstile floor footprint, locate anchoring holes. Drill and install foundation
screw bolts or M12 anchor bolts.
- Align and install the turnstile cabinet on the anchor bolts. Secure the cabinet to
the bolts.
- Follow wiring diagram to terminate the cables on the turnstile control panel. The
following connections are required:
oCard reader to control panel reader port. The control panel can be located
inside the turnstile or outside.
oLane OPEN command from the turnstile to the access control panel door
open relay.
oIf required, an emergency open button or switch can be wired to the
turnstile controller board.
o110Vac (220Vac) is required for each turnstile cabinet.
- For physical installation setup refer to the following drawing.
--Floor anchor installation

Page 8of 8
Chapter 3 –TROUBLESHOOTING AND SUPPORT
For Troubleshooting and Support, please contact HZ Security Inc.:
Tel:
Email:
Website:
+1.631.300.4000
[e-mail]
http://www.turnstileshz.com