U-Line TORK H-5807 User manual

PAGE 1 OF 4 0422 IH-5807
H-5807
TORK®PLASTIC PUSH
FOAM SOAP DISPENSER
1-800-295 -5510
uline.com
NOTE: Install dispenser at least 6" above
counter or sink.
1. Tape included template to wall to use as a guide.
Ensure template is level. (See Figure 1)
Figure 1
6"
2. Drill four holes using 1/4" drill bit and remove
template from wall. (See Figure 2)
Figure 2
INSTALLATION
PARTS
TOOLS NEEDED
LevelTape Measure1/4" Drill BitDrill Phillips Screwdriver
Screw x 4Dispenser x 1 Wall Anchor x 4Key x 1
Template

PAGE 2 OF 4 0422 IH-5807
INSTALLATION CONTINUED
INSTRUCTIONS
3. Insert anchors and screws. (See Figure 3)
NOTE: Do not tighten screws completely until
step 6.
Figure 3
4. Open dispenser and hold up to wall. Align holes
over screws. (See Figure 4) See "Opening" on page 4.
Figure 4
5. Lower dispenser onto screws. (See Figure 5)
Figure 5
6. Tighten screws. (See Figure 6)
Figure 6
LOADING
1. Before loading, turn collar of refill counterclockwise
until click is heard. (See Figure 7)
Figure 7
Refill

PAGE 3 OF 4 0422 IH-5807
2. Flip refill upside down and load into dispenser with
nozzle down. (See Figure 8)
Figure 8
3. Push refill down until it clicks into place.
(See Figure 9)
Figure 9
4. Close cover. (See Figure 10)
Figure 10
5. Push lever to dispense soap. (See Figure 11)
F i g u re 11
INSTRUCTIONS CONTINUED

PAGE 4 OF 4 0422 IH-5807
MAINTENANCE
Clean dispenser with mild detergent and soft cloth.
1
-800-295-551
0
uline.com
OPENING USING KEYED OPTION
1. Insert key at position A. (See Figure 12)
Figure 12
2. Turn and hold key clockwise to open dispenser.
(See Figure 13)
NOTE: Release key back to position A after
closing to lock dispenser.
Figure 13
OPENING USING NON-KEYED PUSH
BUTTON OPTION
1. Insert key at position A and rotate counterclockwise
to position B. (See Figure 14)
Fig ure 14
2. Remove key while in position B and push button to
open dispenser. (See Figure 15)
Figure 15
OPENING