U-Line H-2597 User manual

PAGE 1 OF 2 0620 IH-2597
πH-2597
PLASTIC WALL MOUNT
SANITARY NAPKIN
RECEPTACLE
1-800-295-5510
uline.com
TOOLS NEEDED
Drill Drill Bit Phillips Screwdriver
Receptacle x 1 Liner x 1
Adhesive Strip x 2 Screw x 2
Level Tape Measure
PARTS
MOUNTING INSTRUCTIONS
NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition.
Enclosed hardware may not be compatible
with wall surface.
NOTE: Recommended mounting height is
approximately equal to toilet tissue dispenser.
SCREWS
1. Hold up receptacle to desired location and mark two
holes on the wall where screws will be inserted.
(See Figure 1)
2. Drill into wall at two marked locations with
appropriate-sized drill bit. Insert wall anchors if
necessary.
3. Hold receptacle over previously drilled holes and
insert screws.
ADHESIVE STRIPS
1. Remove backing from adhesive strips.
2. Firmly press onto receptacle. (See Figure 2)
3. Remove secondary backing from strips. Press
receptacle firmly onto surface.
Figure 1
Figure 2
Mounting Locations
Recommended
Placement

PAGE 2 OF 2 0620 IH-2597
1. Open top of receptacle.
2. Place an open liner (S-15960) down into receptacle.
NOTE: Liner should be tucked behind the
receptacle arms. (See Figure 3)
TOP REMOVAL
1. Open the door on top of receptacle. (See Figure 4)
2. Carefully pinch both sides of liner and pull up.
Dispose of liner into trash container.
BOTTOM REMOVAL
1. Place trash container underneath receptacle.
2. Grasp the center-bottom of the receptacle and pull
outward. Liner will fall into the trash container.
(See Figure 5)
LINER LOADING INSTRUCTIONS
LINER REMOVAL INSTRUCTIONS
Figure 3
Figure 4
Figure 5
πCHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com