U-Line H-2789 User manual

PAGE 1 OF 2 0319 IH-2789
πH-2789
FOLDING CHAIR
DOLLY –2 TIER
1-800-295-5510
uline.com
PARTS
ASSEMBLY
Nut x 12 Bolt x 12 End Cap x 24
T-Bar x 2
Base Crossbeam x 1Crossbeam with Chair Hanger x 2
TOOLS NEEDED
Rubber Mallet Wrench
1. Ensure there are no missing or damaged parts.
2. While holding up one of the T-bars (A), bolt
crossbeam (B) into the middle set of holes.
(See Figure 1)
NOTE: There are three holes in the middle set.
Use the two lower holes. (See Figure 1)
3. Bolt the other side of the crossbeam (B) to the
opposite T-bar (A) in the middle set of holes.
(See Figure 2)
NOTE: There are three holes in the middle set.
Use the two lower holes. (See Figure 2)
Figure 1 A
B
Figure 2 A
B

PAGE 2 OF 2 0319 IH-2789
ASSEMBLY CONTINUED
4. Bolt the second crossbeam (B) to the top set of holes
of each T-bar (A). (See Figure 3)
5. Finally, bolt base crossbeam (C) to the bottom set
of holes of each T-bar (A). (See Figure 4)
6. Using a rubber mallet, attach end caps to the chair
hangers. (See Figure 5)
7. Tighten all bolts securely with wrench.
Figure 3
Figure 4
Figure 5
πCHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
A
A
C
A
A
B