Uberhaus 70395001 User manual

70395001
HO-0245
1
OIL FILLED HEATER
PLEASE READ AND SAVE THESE INSTRUCTIONS
OWNER’S MANUAL
3068797

3. Extreme caution and reasonable supervision is necessary when any heater is used
by or near children or invalids and whenever the heater is left operating and
unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. If the heater has
leaked any oil, discontinue using the heater. Return heater to an authorized
service facility for examination, electrical or mechanical adjustment, or
repair.
6. Do not use outdoors.
7. This heater is not intended for use in any area where there is standing water. Never
locate heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners
or the like. Arrange cord away from traffic areas, where it will not be tripped
over.
9. To disconnect the heater, turn controls to (OFF), then remove the plug from
outlet.
10.Connect to properly polarized outlets only.
11.Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause anelectric shock, fire,or damage the heater.
12.To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.
13.A heater has hot or arcing or sparking parts inside. Do not use it in areas
where gasoline, paint or flammable liquids are used or stored.
2
IMPORTANT INSTRUCTIONS
WARNING!
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock, and injury to persons,
including the following.
INSTRUCTIONS FOR USE AND CARE
1. Read all instructions before using heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. If provided, always use handles when moving this heater. Keep
flammable materials such as furniture, pillows, bedding, papers, clothes and
curtains at least 3 feet (0.9m) from the front of the heater and keep them away
from the sides and rear.
14.Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, injury to persons or damage
property.

No. 14 AWG minimum size and rated not less than 1875 W, and has to be used
only for supplying power to this heater.
19.Be sure that the plug is fully inserted into appropriate receptacle. Please remember
that receptacles also deteriorate due to aging and continuous use: check
periodically for signs of overheating or deformations evidenced by the plug. Do not
use the receptacle, and CALL your electrician!
20.Check that neither the appliance nor the power cable has been damaged in any way
during transportation.
21.Make sure that no pieces of polystyrene or other packaging material have been left
between one element of the appliance and another. It may be necessary to pass over
the appliance with avacuumcleaner.
22.When switching on the appliance for the first time, allow it to run at full
power for about two hours to get rid of the unpleasant smell. Make sure that
the room in which the appliance is located is well ventilated during this
operation. It is normal for the appliance to emit small cracking sounds when
you turn it on if the first time.
23.Disposal of oil contained within should be in accordance with applicable regional,
national, and local laws and regulations.
CAUTION: To prevent electric shock match wide blade of plug to wide
slot, fully insert.
SAVE THESE INSTRUCTIONS
3
15.To prevent overload and blown fuses, be sure that no other appliance is plugged
into the same outlet (receptacle) or into another outlet (receptacle) wired into the
same circuit.
16.It is normal for the heater’s plug and cord to feel warm to the touch. A plug or cord,
which becomes hot to the touch or becomes distorted in shape, may be the result of
a worn electrical outlet. Worn outlets or receptacles should be replaced prior to
further use of the heater. Plugging heater into a worn outlet/receptacle may result in
overheating of the power cord or fire.
17.Ensure the heater is on a stable, secure surface to eliminate the potential of tipping
it over.
18.We do not recommend use of an extension cord as it may overheat and cause a
risk of fire. However, if you have to use an extension cord, the cord should be

LEG ASSEMBLY INSTRUCTIONS
DO NOT OPERATE THIS HEATER WITHOUT REAR LEG SUPPORT
ATTACHED (See Fig.1).
Fig. 1
CAUTION: Operate the heater in upright position only. Any other position
could create a hazardous situation.
Ensure that the surface beneath the heater is clean and free of any obstructions. It is
not recommended that this heater be placed on high-pile carpeting or any other
surface that impedes the flow of air underneath the heater.
4

3. When the room reaches the desired temperature, turn the thermostat knob
counter-clockwise very slowly and carefully until you hear a “click.” This will
automatically set your unit to cycle on and off at that desired heat setting. Note: It will
normally require approximately 15 minutes to reach operating temperature.
4. If you want to change the temperature, turn thermostat clockwise to raise the temperature,
or counter-clockwise to lower.
5. To completely shut unit off, the POWER SWITCH must be placed in (OFF) position.
6. Your heater is equipped with an overheat protection system that shuts the unit off if it
overheats due to abnormal conditions. At this time, the CAUTION LIGHT comes on. If
this occurs, turn the heater off (OFF) and unplug it. Then, inspect and remove any
objects on or adjacent to the heater. Allow it to cool for a few minutes, plug it back in, and
resume normal operation.
CARE AND CLEANING
Always remove the plug from the power socket and allow heater to cool. Wipe heater
with a soft damp cloth. Do not use detergents and abrasives.
Should the heater be left unused over a certain length of time, wind the cable round the
holder, and store it in a dry place.
This heater was produced according to ETL specifications and should provide you with
5
OPERATING INSTRUCTIONS
1. Insert the plug into a properly polarized 120 V AC outlet in perfect working condition.
2. Press POWER SWITCH to “o”(ON). Turn thermostat clockwise to the position.

6
hazard or electric shock.
Permanently Sealed – requires no oil change.
Your product is equipped with a polarized alternating current line plug (a plug
having one blade wider than the other). This plug will fit into the power outlet
only one way. This is a safety feature. If you are unable to insert the plug fully into
the outlet, try reversing the plug. If the plug should still fail to fit, contact your
electrician to replace your obsolete outlet. Do not defeat the safety purpose of the
polarized plug.
SPECIFICATIONS
Model No.: 70395001
Voltage: 120V, 60Hz
Current: Maximum 5.83 Amps.
Power: 700 Watts
Tolerances on all specifications: not exceeded than 105%
In case of malfunction, do not try to repair the heater
by yourself. It may result in fire
years of trouble-free service.

Warranty
Thank you for investing in a UBERHAUS product. These products have been
made to quality standards and are guaranteed for domestic use against
manufacturing faults for a period of 12 months from the date of purchase.
This guarantee does not affect your statutory rights. In case of any malfunction of
your product (failure, missing part, etc.), please contact one of our service
technician at our toll free service line at 1-866-283-2239 from 8 AM to 6 PM,
Monday to Friday, Eastern time. RONA reserves the right to replace the defective
tool, at its discretion.
Normal wear and tear, including accessory wear, is not covered under guarantee.
The product is guaranteed for 12 months if used for normal trade purposes. Any
guarantee is invalid if the product has been overloaded or subject to neglect,
improper use or an attempted repair other than by an authorized agent.
Heavy-duty, daily professional or hire usage are not guaranteed. Due to
continuous product improvement, we reserve the right to change the product
specification without prior notice.
PRINTED IN CHINA