Uberhaus HO-0221 User manual

1
OWNER’S MANUAL
OIL FILLED HEATER
70395000
HO-0221
PLEASE READ AND SAVE THESE INSTRUCTIONS
3068797

2
IMPORTANT INSTRUCTIONS
WARNING! When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock, and injury to persons,
including the following.
INSTRUCTIONS FOR USE AND CARE
1. Read all instructions before using heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. If provided, always use handles when moving this heater. Keep
flammable materials such as furniture, pillows, bedding, papers, clothes and
curtains at least 3 feet (0.9m) from the front of the heater and keep them away
from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
4. Always unplug the heater when not in use.
5. Do not operate the heater with a damaged cord or plug, if the heater malfunctions,
has been dropped or damaged in any manner. Return heater to an authorized service
facility for examination, electrical or mechanical adjustment, or repair.
6. Do not use the heater outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar moist
indoor locations. Never locate heater where it may fall into a bathtub or other
water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or
the like. Arrange cord away from traffic areas where it can be tripped over.
9. CAUTION: This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of shock, this plug is intended to fit only one way in
a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician. DO NOT attempt to
defeat this safety feature. To do so could result in an electric shock hazard.
10. This heater draws 12.5 amps during operation. To prevent overloading a circuit,
do not plug the heater into a circuit that already has other appliances working.
11. CAUTION: It is normal for the plug to feel warm to the touch; however, a
loose fit between the AC outlet (receptacle) and plug may cause overheating
and distortion of the plug. Contact a qualified electrician to replace a loose or
worn outlet.
12. To disconnect the heater, first turn controls to the OFF position, then remove
plug from outlet. Never unplug by pulling the cord.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust opening
as this may cause an electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do
not use on soft surfaces, like a bed, where openings may become blocked.

3
15. A heater has hot and arcing or sparking parts inside. Do not use it in the areas
where gasoline, paint, or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, or injury to persons.
17. CAUTION: Avoid the use of an extension cord because the extension cord
may overheat and cause a risk of fire. However, if you have to use an
extension cord, the cord shall be No.14 AWG minimum size and rated not
less than 1875 watts.
18. The output of this heater may vary and its temperature may become intense
enough to burn exposed skin. Use of this heater is not recommended for persons
with reduced sensitivity to heat or an inability to react to avoid burns.
19. This heater includes a caution indicator to warn that parts of the heater are getting
excessively hot. If the caution indicator light flashes, immediately turn the heater
off and inspect for any objects on or adjacent to the heater that may cause high
temperatures. DO NOT OPERATE THE HEATER WITH THE CAUTION
INDICATOR LIGHT FLASHING.
SAVE THESE IMPORTANT INSTRUCTIONS FOR
EASYREFERENCE.

ASSEMBLY
Unpack your heater and remove the wheel assemblies from the package. Refer to Fig.
below:
1. Make sure the heater is unplugged and
in the “OFF” position.
2. Turn the heater upside down.
3. Position the wheel base assemblies
between the end fins as shown.
4. Insert each U-shape screw into the
holes of each wheel holding plate.
5. Insert the butterfly nuts and screw them
tightly.
6. Turn the heater upright.
Your heater is now ready for use.
CAUTION: Risk of fire – Do not operate heater without wheel assemblies attached.
Operate heater in upright position only (wheels on bottom, controls on top). Any
other position could create a hazardous situation.
ELECTRICAL RATINGS
This product is rated 12.5 amps (1500W) at 120V, 60 Hz.
OPERATING INSTRUCTIONS
Wheel
holding
plate
U-shape
Screw
IMPORTANT!
Your heater is equipped with a polarized
alternating current line plug (a plug having
one blade wider than the other). This plug
will fit into the power outlet only one way.
This is a safety feature. If you are unable
to insert the plug fully into the outlet, try
reversing the plug. If the plug should still
fail to fit, contact your electrician to
replace your outlet.
safety purpose of the polarized plug.
DO NOT defeat the
safety purpose of the polarized plug.
A
B
C
D
Control Panel Functions
Power Indicator Light Thermostat Control
Power and Setting Control Caution Indicator Light
A B
C D
4

5
1. Check that neither the appliance nor the power cable has been damaged in any
way during transportation before its first use.
2. Place the heater on a firm, level surface free from obstructions, and at least 3 ft.
(0.9m) away from any wall or flammable material.
3. With the Power and Setting Control “C” in the “0” position, plug the heater
into a grounded 120V outlet. Always operate the heater in the upright position.
4. To turn the heater on, turn the Power Switch knob clockwise to the desired
position (I/II/III) and turn thermostat to your desired setting from (MIN)
to (MAX). The Power Indicator Light “A” will illuminate when operating.
The power settings operate as follows:
0: The heater turns off;
I:The heater operates at 600 watts;
II:The heater operates at 900 watts;
III:The heater operates at 1500 watts.
5. When the room reaches a comfortable temperature, slowly turn the Thermostat
Control “B” counter-clockwise until you hear a “click” sound. This is the point
at which the thermostat setting equals the room temperature. At this setting, the
thermostat will automatically turn the heater on and off to maintain this selected
temperature.
6. Turn the Power and Setting Control “C” to “0” to turn it off, and then unplug
the heater when you finish using it.
CAUTION INDICATOR LIGHT: This heater includes a caution indicator to warn
that parts of the heater are getting excessively hot. If the caution indicator light (D)
flashes, immediately turn the heater off and inspect for any objects on
or adjacent to the heater that may cause high temperatures. DO NOT
OPERATE THE HEATER WITH THE CAUTION INDICATOR LIGHT
FLASHING.

6
RESET INSTRUCTIONS
This heater is equipped with an internal high limit switch, which causes the unit to
stop operating in the event the internal temperature exceeds normal operating
temperatures.
IF THE UNIT SHUTS DOWN:
1) TURN THE UNIT OFF
2) UNPLUG UNIT AND WAIT 10 MINUTES
3) PLUG IN AND TURN ON
IF YOUR HEATER FAILS TO OPERATE:
Be sure it is plugged in and that the electrical outlet is working.
Check for any obstruction. If you find an obstruction turn the heater OFF. Unplug
the heater and wait at least ten minutes for it to cool. Carefully remove the
obstruction. Plug the heater back in and restart it as described under OPERATION.
If you still notice the same defect above mentioned, remove the plug from the
socket and have the appliance serviced by authorized service personnel only.
Check that the thermostat is not set too low. With the power switch set to a heat
setting, turn the thermostat up (clockwise) until the heater restarts.
CLEANING AND STORAGE
We recommend that the heater be cleaned at least once a month and before
off-season storage.
Turn the heater OFF and unplug it. Allow it to cool.
Use a dry cloth to clean the external surfaces of the heater.
DO NOT USE WATER, WAX, POLISH ORANY CHEMICAL SOLUTION.
Clean your heater using the above-mentioned steps, then pack the heater in its
original container and store it in a cool dry place.
The motor is factory lubricated for life, and will require no further lubrication.
SPECIFICATIONS
Model No.: 70395000
Voltage: 120V, 60Hz
Current: Maximum 12.5 Amps.
Power: 1500 Watts
Tolerances on all specifications: not exceeded than 105%

Warranty
Thank you for investing in a UBERHAUS product. These products have been
made to quality standards and are guaranteed for domestic use against
manufacturing faults for a period of 12 months from the date of purchase.
This guarantee does not affect your statutory rights. In case of any malfunction of
your product (failure, missing part, etc.), please contact one of our service technician
at our toll free service line at 1-866-283-2239 from 8 AM to 6 PM, Monday
to Friday, Eastern time. RONA reserves the right to replace the defective tool, at
its discretion.
Normal wear and tear, including accessory wear, is not covered under guarantee.
The product is guaranteed for 12 months if used for normal trade purposes. Any
guarantee is invalid if the product has been overloaded or subject to neglect,
improper use or an attempted repair other than by an authorized agent.
Heavy-duty, daily professional or hire usage are not guaranteed. Due to
continuous product improvement, we reserve the right to change the product
specification without prior notice.
PRINTED IN CHINA