Ubiquiti UniFi UAP-FlexHD User manual

UniFi AP FlexHD Base Mount Outdoor Mount
Wall/Pole Mount PoE Adapter* (48V, 0.32A) Power Cord
Zip Ties (Qty. 2) Screws (Qty. 2) Screw Anchors (Qty. 2)
Package Contents
* Included only in the single-pack of the UAP-FlexHD
Installation Requirements
Phillips screwdriver
Cat5/6 UTP cable for indoor installations
Shielded Category 5 (or above) cabling should be used for all outdoor wired
Ethernet connections and should be grounded through the AC ground of the
PoE.
System Requirements
UAP-FlexHD Quick Start Guide

LED
UniFi Cloud Key or Dream Machine, or machine running Linux, Mac OS X, or
Windows 7/8/10
Java Runtime Environment 1.8 or above recommended
Web Browser: Google Chrome (Other browsers may have limited functionality.)
UniFi Controller software v5.11.31 or newer (available at: ui.com/download/unifi)
Hardware Overview
White Factory default, waiting to be integrated.
Flashing White Initializing.
Alternating White/Blue
Device is busy; do not touch or unplug it. This
usually indicates that a process such as a
firmware upgrade is taking place.
Blue Indicates the device has been successfully
integrated into a network and is working properly.
UAP-FlexHD Quick Start Guide

Ethernet Port
Reset Button
Quickly Flashing Blue
This is used to locate an AP.
When you click Locate in the UniFi Controller
software, the AP will flash. It will also display the
location of the AP on the map.
Steady Blue with
Occasional Flashing
Indicates the device is in an isolated state (all
WLANs are brought down until an uplink is found).
This Gigabit Ethernet port is used to connect 802.3af PoE power and should be
connected to the LAN and DHCPserver.
The Reset button serves two functions for the UniFi AP:
Restart Press and release the Reset button quickly.
Restore to Factory Default Settings Press and hold the Reset button for
more than five seconds.
Installation
Determine the installation location of the UAP FlexHD:
Desktop The UAP FlexHD stands freely on a horizontal surface such as a
desktop or table/shelf. Good for temporary installations.
Wall The UAP FlexHD is attached to a wall in a secure location.
Ceiling The UAP FlexHD is mounted in a ceiling tile (requires optional recessed
ceiling mount assembly, sold separately).
Pole The UAP FlexHD is attached to a pole (indoor or outdoor).
Note: When installing Ethernet cabling on a pole or up the outer surface of
a wall, use RJ45 connectors without strain-relief boots on them. This will
prevent unnecessary tension on the cable ends.
Cable without a strain-relief boot Cable with a strain-relief boot
Proceed to the appropriate section for your installation.
Desktop
1.
UAP-FlexHD Quick Start Guide

2.
3.
UAP-FlexHD Quick Start Guide

4.
Wall
1.
UAP-FlexHD Quick Start Guide

2.
3.
UAP-FlexHD Quick Start Guide

4.
UAP-FlexHD Quick Start Guide

5.
UAP-FlexHD Quick Start Guide

Ceiling (Optional Accessory)
Use the optional Ceiling Mount, Mount Cover, and Back Plate
Assembly to install the UAP FlexHD on a drop tile ceiling or
horizontal surface where the interior side of the Ceiling Mount
is accessible.
1.
UAP-FlexHD Quick Start Guide

2.
UAP-FlexHD Quick Start Guide