Uplift Desk Coffee Table Legs User manual

For assembly assistance,
visit upliftdesk.com, call 800-349-3839
or email [email protected]
355 lb
two person
assembly
Patent Pending, ©2020 UPLIFT Desk®. All Rights Reserved
Coffee Table Legs
®

Thank you for choosing UPLIFT Desk.

© UPLIFT Desk • 800-349-3839 • 512-614-3152 • [e-mail] • upliftdesk.com
3
Count all pieces before disposing of any carton or packing material. Use a padded or carpeted area
for assembly to avoid damage. For ease and safety, we recommend two people for assembly.
355 lb
355 lb
You’ll need:
Tape measure,
and Phillips head
screwdriver
CONTENTS
PACKAGE CONTENTS
Screws
(qty 16)
Legs
(qty 2)
Washers
(qty 16)
CONFIGURATION

© UPLIFT Desk • 800-349-3839 • 512-614-3152 • [e-mail] • upliftdesk.com 4
ASSEMBLY INSTRUCTIONS
Step 3
Align the leg mounting holes with the pencil marks
or drilled holes and attach using the included Screws
and Washers.
Do not overtighten to avoid stripping.
Step 4
With the help of another person, carefully rotate the
assembled table upright and position it where you
would like it to be.
Step 2
There are no predrilled holes on UPLIFT Desks for at-
taching Coffee table legs, so choose locations you pre-
fer that do not interfere with existing predrilled holes
or grommet holes. Use a tape measure to ensure the
legs are evenly spaced from the ends of the table top
and from front to back. We recommend placing the
legs no more than a few inches in from each end to
ensure stability.
Once legs are in place, mark each mounting hole with
a pencil.
If you own a drill, you can make this a little easier by
drilling pilot holes where you’ve made your pencil
marks using a 1/8” diameter bit.
Note: DRILL NO DEEPER THAN 1/2”. To ensure
this, we recommend wrapping a piece of tape
around your drill bit 1/2” from the tip. Stop drill-
ing just before the tape touches the desktop.
Step 1
Check the top of your table top for damage prior
to assembly. Place your table top upside down on a
debris-free carpeted area or a blanket. Make sure the
table top is upside down. Most UPLIFT Desktops are
predrilled for our desk frames - ignore these holes.
1/2’’
Copyright Notice: These instructions are a component of this accessory. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website: uplift-
desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may
result in damage or personal injury. Retain manual for future reference.
CAUTIONS & WARNINGS
!
!
AI-FRM404-1.190.014.01.1015v.A