Uplift Desk TOP314 User manual

Step 3
Get ready to attach the desk frame to the Table. Make sure the frame
is assembled as per its instructions before you begin. Line up your
desk’s frame with the pre-drilled holes with threaded inserts on the
Table, and attach using the #10-24x5/8’’ Machine Screws that came
with the frame.
If you have further questions regarding assembly of your UPLIFT
Desk frame, refer to those instructions.
Package Contents
®
Crafting Table Top
TOP314
Step 1
Open your box and dispense of its cardboard and packaging. Take a
moment to put some masking tape on the drawers and lids, so they
stay closed while moving, ipping over, and assembling your desk.
If you do not use tape, loose drawers and lids may open suddenly,
possibly damaging the table or causing injury.
Step 2
Place some towels or a blanket on the oor to protect the Table.
Have a friend or two help you place the Table upside down on the
blanket, so that the screw holes are facing up.
Craft Table Top
© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com TOP314/R01
NOTE
Masking tape or Painter’s tape should be strong enough to keep drawers and hatches
closed, while also being gentle enough to not damage or gum up your Craft Tabletop’s
wood surface. Do NOT use other types of tape, such as Scotch or Duct tape.

© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com
Copyright Notice: These instructions are a component of the Crafting Table. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website:
upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
CAUTION: Read all instructions before assembly. Failure to assemble properly may result in
damage or personal injury.
WARNING: Exercise caution with the table’s hinged lids as they can slam shut and cause injury.
CAUTIONS & WARNINGS
!
!
!
Compatible with other UPLIFT Desks
The pre-drilled holes on this Table will also work
with the frame components of the
UPLIFT Desk 4-leg Side Table
and T-Frame Desks
Step 4
Once the Table is secured to the frame, grab your friend to help you
ip it over safely. Grasp the desk frame and desktop, being careful to
support both equally, so you do not stress the screws or pull them
loose.
Now, ip the Table over. Adjust the leveling studs on the feet to en-
sure that it is level.
Once it is right-side up, carefully remove the masking tape.