Uplift Desk CPU128-NTS User manual

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
Track guard16’’ Track Back bumper UPLIFT CPU Holder
Track Spacer Kit
(optional)
5/8’’ Wood screws
(qty 12)
Allen wrench
*A note before you begin:
If you purchased the optional Track Spacer, please follow those instructions.
Package Contents
CPU Holder
SKU: CPU128-NTS
Step 1
Hold the Track under your desk to see where it will t. Mark the
location of the ten screw holes in the track with a pencil.
Step 2
If you own a drill, you can make this a little easier by drilling
pilot holes where you’ve made your pencil marks using a 1/8”
diameter bit.
Note: DRILL NO DEEPER THAN 1/2” because that will
increase the risk of drilling through your desktop. We
recommend wrapping a piece of tape around your drill
bit 1/2” from the tip. Stop drilling just before the tape
touches the desktop.
Step 3
Attach the track to the underside of the desk by using eight Wood
screws and a Phillips head screwdriver.
Note: Your desktop must be at least 3/4” thick for the provided
Wood screws.
Step 4
Using one Wood screw, attach the rubber Back bumper to the
rear side of the track.
Step 5
Use the Allen wrench to loosen the three bolts on the side of the
CPU holder. This will loosen the lower half of the vertical clamp,
and allow you to slide it to its full height.
1/2’’

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
Step 7
Place your CPU into the holder, and reverse what you did in Steps
5 and 6. Slide the lower half of the vertical clamp up to hold the
CPU, and tighten the bolts.
Tighten the top center bolt to bring the horizontal clamp inward
and hold the CPU securely.
Step 8
Slide the CPU and CPU Holder onto the track.
Step 9
Use the three remaining Wood screws to attach the Track guard
to prevent the CPU Holder from sliding off.
Refer to the “mark-up” and “pre-drill” instructions from Steps 1
and 2 for the outer holes on the Track guard.
Step 6
Use the Allen wrench to loosen the upper bolt, shown here, on the
on the CPU holder. Loosen the bolt until the horizontal clamp is
wide enough for your CPU to t inside.
CAUTION: Read all instructions before assembly and use. Failure to assemble and operate
properly may result in damage or personal injury. Retain manual for future reference.
CAUTIONS & WARNINGS
!
!
Copyright Notice: This guide is a component of this product. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may not be
forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
AI-CPU128-NTS-1.0