Uplift Desk MVT013 User manual

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
Package Contents
Elevate Footrest
SKU: MVT013
Step 1
Paying attention to the orientation, insert the Handle
into the tubes on the Base as shown until the spring
pins click into place. You may need to depress the
spring pins slightly with your nger to get them into
the base.
Step 2
A. Estimate the Platform height you prefer by hold-
ing it next to the Handle and Base assembly. If the
use will be similar to a bar foot rail while stand-
ing, we recommend setting the Platform height to
around 7” using the second holes from the bottom
in the Handle.
B. Holding the Platform vertical as shown, insert the
hooks on the back of the Platform into the holes
along the handle that you selected in the previous
step. Make sure the Handle holes are at the same
height on each side so the Platform sits level.
C. Rotate the Platform down until the back of the
Platform rests against the Handle
Step 3 (optional)
A. If you choose to place the Platform directly on the
oor without using the base, rst put an End Cap
on each of the Platform’s hooks.
B. Remove the paper backing from each of the four
Pads and place them on the bottom of the Plat-
form.
Handle Platform Pad (qty 4)Base End Cap (qty 2)

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may result in
damage or personal injury. Retain manual for future reference.
CAUTION: Only use this product when assembled per instructions.
CAUTION: This product must be used on a level surface for proper stability.
WARNING: Never use this product if it does not perform according to this sheet.
Due to continual improvement of products, illustrations and photographs may not reect exact product appearance.
WARNING: Do not stand or sit on the Elevate Footrest.
CAUTIONS & WARNINGS
!
!
!
!
!
!
Copyright Notice: These instructions are a component of this accessory. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website: uplift-
desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
AI-MVT013-1.0
Adjustment Information
Adjust the height of the Platform
A. To adjust the height of the Elevate Footrest, rotate
the Platform up to disengage the Platform’s hooks
from the Handle. See Step 2B and 2C for details
on removing and installing the Platform into the
Handle at the new height.
B. Determine how much higher or lower you would
like the Platform to be and select the holes on the
Handle that would best position the Platform at
that height.
• There are six height options available on the
Handle, or you can rest the Platorm on the oor.