Uplift Desk STR041 User manual

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
Package Contents
3-Drawer Narrow Square File Cabinet
SKU: STR041
To prevent tipping, the max load of the top 2 drawers is 10 lbs each and the max load of the bottom drawer
is 35 lb.
STEP 1
A. After unboxing the File Cabinet, unlock the
drawers and remove the casters, Pencil Tray, and
hardware from the top drawers.
B. Grab a friend to help you turn the File Cabinet
upside down on a clean blanket or carpet to
protect the top surface from scratches. Be
careful to keep the drawers from opening while
turning the File Cabinet over.
C. Pull out the bottom drawer, exposing the top
and bottom sides of the caster mounting holes
located at the 4 corners of the bottom surface.
D. Put a Split Lock Washer on the stem of a Front
Locking Caster and place the stem through one
of the front holes.
E. From the inside of the bottom surface, thread a
Flange Lock Nut onto the Front Locking Caster
stem. Use one 14 mm Flat Wrench to hold the
integrated caster nut and tighten the Flange
Lock Nut with the other 14 mm Flat Wrench.
F. Repeat steps 1.D and 1.E for the remaining
casters, making sure the other Front Locking
Caster is installed in the other hole at the front
of the File Cabinet, and the 2 Rear Casters (non-
locking) are installed in the back.
File Cabinet
(qty 1)
Pencil Tray
(qty 1)
Hanging Folder
Bar (qty 1)
Front Locking
Casters (qty 2)
Rear Casters
(qty 2)
Support
Caster (qty 1)
Split Lock
Washer (qty 4)
14 mm Flat
Wrench (qty 2)
Support Caster
Pin (qty 1)
Flange Lock
Nut (qty 4)
Keys (qty 2)

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
STEP 2 (Optional)
The Support Caster is optional and should be used
if the contents of the bottom drawer might exceed
7.5 lb, which could cause the File Cabinet to tip
forward when opened.
A. Orient the Support Caster as shown so that the
arrow is pointing towards the front of the File
Cabinet and the caster is angled towards the
back of the File Cabinet. Slide into the slots at
the front edge of the File Cabinet until the back
edge of the caster is past the 2 bumps, locking it
in place.
B. You and your friend can now safely turn the File
Cabinet over to its upright position.
C. Test the casters by rolling the File Cabinet
around a bit to ensure it is stable.
D. Insert the Support Caster Pin into the hole inside
the bottom drawer. This will secure the Support
Caster in place and keep it from dislodging.
STEP 3 (Optional)
A. To keep your File Cabinet stationary, simply ip
the tabs on the 2 Front Locking Casters into the
“down” position.
STEP 4 (Optional)
A. Open either of the top 2 drawers and insert the
Pencil Tray into the drawer of your choice.
B. There are notches on both sides of the drawer
providing 11 positions for the tray.
C. Tabs on the bottom of the tray align with the
notches in the drawer, preventing the tray from
sliding when the drawer is opened and closed.

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
STEP 5 Optional)
A. Letter and legal-size hanging le folders will
hang lengthwise on the Hanging Folder Bar and
back edge of the bottom drawer, leaving storage
space at the front of the drawer.
B. To move the Hanging Folder Bar, lift up on one
end and gently pull the side of the drawer out to
disengage the bar, then rotate slightly and lift
the bar to disengage the other end.
C. For letter le folders, install the bar in the slots
located closest to the back of the drawer. Note
the orientation of the bar, the folded edge of the
bar should face toward the front of the drawer.
D. For legal le folders, install the bar in the slots
located closest to the front of the drawer. Note
the orientation of the bar, the folded edge of the
bar should face toward the front of the drawer.
STEP 6 Optional
A. If you want to lock all 3 drawers, simply
insert one of the Keys and rotate it 180°
counterclockwise. To unlock the drawer, turn the
key back 180° clockwise. The lock will secure all 3
drawers.
B. If you’d like to keep your key in the lock to avoid
losing it, just ip the tab down so it doesn’t get
snagged on your clothes or personal items.
CAUTION: Read all instructions before assembly. Failure to assemble properly may result in damage or
personal injury.
WARNING: Do NOT stand or sit on the unit. Do not sit on, stand in, or lean on open drawers.
CAUTION: To prevent the unit from tipping over, only have one drawer open at a time.
CAUTION: To prevent tipping, the max load of the top 2 drawers is 10 lbs each and the max load of the
bottom drawer is 35 lb.
CAUTIONS & WARNINGS
!
!
!
!
!
Letter Legal

AI-STR041-1.2
512-614-3152
800-349-3839
[email protected]
upliftdesk.com
Work Better. Live Healthier
Study this manual carefully. If this product is sold,
please provide this manual to the buyer, installers,
or support personnel operating the product.
SAVE THE INSTRUCTIONS
Copyright Notice: This guide is a component of this UPLIFT Desk product. This guide is a part of the
scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website:
upliftdesk.com. These instructions are subject to United States copyright law.
©