Uplift Desk Intuition Ergonomic Chair CHR472 User manual

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
Intuition Ergonomic Chair
SKU: CHR472
Package Contents
STEP 2
A. Place the Seat upside down on the edge of a stable
surface, such as a table.
B. Insert the tab on the Seat into the slot on the Back
and line up the holes on each. Have a friend help keep
the Seat steady while you attach the Back to the Seat
with three M8x20mm Screws and three Split Lock
Washers. Start all screws loosely, then tighten them
all using the Allen wrench.
STEP 1
A. Be cautious around the small end of the Cylinder to
avoid getting grease on you or your clothes.
B. With the Base turned upside down, insert the Caster
stems into the holes in the Base, and press them
rmly to secure them in place.
C. Flip the Base, so the Casters are on the oor, and
insert the Cylinder into the Base in the orientation
shown with the smaller diameter end up.
Casters (qty 5) Base Cylinder Seat Back Arms Headrest
STEP 3
A. Insert the Right Arm into the arm receiver on the Seat
as shown. The arms should angle towards the front of
the chair when installed with the height adjustment
points facing outward.
B. With one M8x32mm Machine Screw and one Split
Lock Washer, fasten the Arm to the Seat through the
opening at the bottom of the Arm using the Allen
Wrench to tighten the Screw. Repeat this process for
attaching the Left Arm.
M8x20mm Screw (qty 3)
m6x17 m8x20 m8x32 split lock washer
m6x17 m8x20 m8x32 split lock washer
m6x17 m8x20 m8x32 split lock washer
M8x32mm Screw (qty 2)
m6x17 m8x20 m8x32 split lock washer
M6x17mm Screw (qty 2) Split Lock Washer (qty 5) Screw Cover Allen Wrench

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
STEP 4
A. Flip the chair assembly from Steps 2 and 3 right-side
up and lower it onto the Cylinder.
B. Press down on the seat (or sit on it) to secure it in
place on the Cylinder.
Note: If you don’t want to install the Headrest, peel off
the paper backing on the Screw Cover and align it with
the oval shape in the top of the chair Back. Press rmly
along the entire length of the Screw Cover for 10 to 20
seconds to secure it in place
If you would like to install the Headrest, follow the
instructions below:
A. Line up the headrest with the screw holes at the top
of the Back and attach it with the two M6x17mm
Screws. Start both Screws loosely, then tighten them
using the Allen Wrench.
B. Peel off the paper backing on the Screw Cover
and align it with the oval shape in the back of the
Headrest. Press rmly along the entire length of the
Screw Cover for 10 to 20 seconds to secure it in place.
STEP 5

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
SEAT HEIGHT ADJUSTMENT
While Seated, adjust by pulling UP on the lever on the
right-hand side of the Seat labeled “LIFT”. Stand up to
raise the chair higher or sit down, to lower it.
Ergo Tip: For proper ergonomics, your feet should be at
on the oor and your thighs should be horizontal. To nd
your optimal settings, refer to our Ergonomic Calculator:
https://www.upliftdesk.com/ergonomic-calculator/
Adjustment Guide
LIF
T
SEAT DEPTH ADJUSTMENT
To change your Seat Depth, nd the lever on the right-
hand side of the Seat labeled “SLIDE” and pull UP to slide
the seat forward or backward to your desired position
and release the lever to lock the Seat.
To return the Seat to the back position, pull the lever UP
and lift yourself off of the Seat. The Seat will slide back
on its own.
SLI
D
E
BACK HEIGHT ADJUSTMENT
To raise or lower the chair Back, press the two metallic
buttons found along the Back. While pressing the
buttons, raise or lower the Back to your desired height
and release the buttons to lock the Back in place. There
are four height adjustment positions to choose from.
Find the one that positions the chair’s lumbar support to
best support your lower back.
Ergo Tip: Supporting your lumbar curve is very important
when sitting for long durations.
Ergonomic Chair

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
HEADREST HEIGHT & ANGLE
ADJUSTMENT
Height- Hold the Headrest rmly and lift or lower it to
your desired height.
Tilt- Hold the Headrest rmly and adjust it at an upward
or downward angle to the position where it’s most
comfortable.
ARMREST ADJUSTMENTS
Height- Pull up on the lever on the side of the Arm to
raise or lower the armrest.
Depth- Grasp arm pads and push forwards or backwards
to desired placement.
Angle- Grasp arm pads and rotate them inwards or
outwards to adjust angle.
Ergo Tip: The arm pad should be positioned to support
as much of the forearm as possible while keeping your
shoulder in a neutral position.

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
RECLINE ADJUSTMENT
There are two types of recline adjustment, recline
tension control and recline position lock.
To adjust the recline tension, rotate the crank clockwise
to increase tension, and counterclockwise to decrease
tension. (see gure A).
To lock the Back in a desired position, nd the lever
on the right-hand side of the Seat labeled “TILT”. Push
DOWN on the lever to allow the chair Back to recline
freely. To lock the chair Back, lean back until it is in the
desired position and pull UP on the “TILT” lever (see
gure B). To return the chair Back to its original position,
push the “TILT” lever DOWN and lean back slightly. You
will hear/feel a “click” which will then allow the chair
Back to return to its original position. (see gure C).
+
-
TIL
T
TIL
T
Figure A
Figure B
Figure C

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
Fabric Care Guide
a note about fabric care
Normal- Vacuum your fabric seat as needed. Vacuuming picks up dust and reduces the need for professional
cleaning.
Ink Stains- Apply a small amount of isopropyl alcohol to a clean and damp absorbent cloth. Start at the outside
of the ink stain and work toward the center. Apply pressure, but do not rub too vigorously. As you work and your
cloth soaks up the ink from the fabric stain, it’s important to use a clean section of the cloth or the stain will
spread. Apply more isopropyl alcohol to the cloth as needed. If the ink stain persists, try using acetone. Note: This
procedure is not intended for day-to-day cleaning.
Spot Cleaning- Immediately soak up the stain with a soft, absorbent cloth. Do not dry the stain completely, as
this may set it in the fabric permanently. The longer a stain is allowed to remain on the fabric, the more difcult it
is to remove.
Oil-based Stains- Use a dry cleaning solution applied with a damp clean cloth or sponge. Test the cleaning
solution on a small, concealed spot on the fabric rst before attempting on a larger area. If there is no spotting,
ringing, or damage to the fabric or its dyes, apply the cleaning solution to the soiled area with light, quick strokes.
Begin at the outside of the stain and work toward the middle, making sure you use a clean part of the cloth as you
work.
Water-based Stains- Use a water-based fabric cleaner (specically made for cleaning fabric) or a solution of
mild, alkaline, warm soapy water. Make sure that the soap and water mixture is not overly soapy. Test on a small,
concealed section of the fabric rst before applying to the main area. Work the cleaner or soap/water mixture into
the stain on the fabric, starting from the outside of the fabric and working your way to the middle.
CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may result in
damage or personal injury. Retain manual for future reference.
WARNING: This product’s maximum weight capacity is 300 lbs (136 kg). DO NOT exceed the maximum
weight capacity.
WARNING: Do not use this chair as a step stool or ladder.
CAUTIONS & WARNINGS
!
!
!
!

© UPLIFT Desk • 800-349-3839 • [e-mail] • upliftdesk.com
Notes

AI-CHR472-1.0
512-614-3152
800-349-3839
[email protected]
upliftdesk.com
Work Better. Live Healthier
Copyright Notice: This guide is a component of this UPLIFT Desk product. This guide is a part of the scope of delivery, even if the item is resold.
This guide is also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other
published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
Study this manual carefully. If this product is sold,
please provide this manual to the buyer, installers,
or support personnel operating the product.
SAVE THE INSTRUCTIONS