Uplift Desk ACC067 User manual

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
Package Contents
Flexible Desk Hook
ACC067
Step 1
A. Separate Mounting Clip slightly and slip over Hook
as shown.
B. Slide Mounting Clip up to top of Hook.
C. Flip Mounting Clip 180 degrees over the top of
the Hook.
Flexible Hook #10x5/8’’ Wood Screws
(qty 2)
Mounting Clip
Step 2
Determine your mounting method. There are two
ways to attach the Flexible Desk Hook to your desk-
top:
Install Using Pre-drilled Holes: If you would like to at-
tach the Desk Hook to your UPLIFT Desk using the
pre-drilled keypad holes on the front, left or right side,
follow the “Installation Using Pre-drilled Holes” in-
structions (Step 3).
Install Without Using Pre-drilled Holes: If you do
not have an UPLIFT Desktop with pre-drilled holes or
choose to place the Hook in a different location, fol-
low the “Installation Without Using Pre-drilled Holes”
instructions (Step 4).
Using
Pre-drilled Holes
Without Using
Pre-drilled Holes

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
Copyright Notice: These instructions are a component of this accessory. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website: uplift-
desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may
result in damage or personal injury. Retain manual for future reference.
CAUTIONS & WARNINGS
!
!
AI-ACC067-1.0
1/2’’
Step 3 (Installation Using Pre-drilled Holes)
A. Most UPLIFT desktops include pre-drilled holes on
the front, left and right sides for attaching the key-
pad. The Mounting Clip was designed to attach to
the set of pre-drilled holes that are not being used
for your desk’s keypad.
B. Line up the Mounting Clip with the two holes that
are closer together in the orientation shown and
attach it with the two #10x5/8’’ Wood Screws.
C. Do not over tighten to avoid stripping.
Step 4 (Installation Without Using Pre-drilled Holes)
A. If you do not have an UPLIFT Desktop with pre-
drilled holes or choose to place the Hook in a dif-
ferent location, hold the Mounting Clip where you
would like to install it and attach it to your desktop
using the two #10x5/8’’ Wood Screws through the
two mounting holes.
B. If you own a drill, you can make this a little easi-
er by drilling pilot holes. Hold the Mounting Clip
where you would like to attach it and make a
pencil mark on the desktop in the center of each
mounting hole.
C. Next drill a pilot hole at each pencil
mark using a 1/8” (or 3mm) diameter bit.
Note: DRILL NO DEEPER THAN 1/2”.
To ensure this, we recommend wrapping
a piece of tape around your drill bit 1/2”
from the tip. Stop drilling just before the
tape touches the desktop.
D. Attach the Mounting Clip and Hook to the desktop
using the #10x5/8” Wood Screws.
Step 5
A. Bend the prongs of the Hook to the shape that
best suits the item you plan to hang on them. Use
your Hook to hold large headphones, gaming con-
trollers, headsets, water bottles, purses, coiled ca-
bles, or other items.
B. Maximum weight limit for the installed Hook is 10
pounds.