Uplift Desk CHR455 User manual

© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com
Step 1
Insert the casters into each end of the base, then insert the cylinder into the base.
Step 2
Lower the seat onto the cylinder.
Step 3
Sit in the chair, and ip the lever on the left side to the “up” position (gure 1).
Lean back until you feel it click.
This unlocks the tilt to allow the seat to be upright.
Package Contents
®
Pursuit™ Ergonomic Chair
CHR455
SeatBaseCasters
(qty 5)
Cylinder
gure 1
Step 4
There’s a compartment under the seat, which could store these instructions
or other small items.
CHR455/R03

© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com
Copyright Notice: These instructions are a component of the UPLIFT Pursuit™ Ergonomic Chair. These instructions are part of the scope of delivery, even if the item is
resold. These instructions are also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other
published form without the prior written consent of UPLIFT Desk.
These instructions are subject to United States copyright law.
©
Seat Height
Squeeze lever under the right-hand side, beside the crank (a), to raise and
lower the height of the seat (b).
Back Height
Press forward on the back, until you feel the back unlock, allowing you to
adjust it to your desired height.
(a)
(a)
(c)
(b)
(b)
Adjustment Guide
Armpad Angle
Grasp armpads and rotate them inward or outward to adjust elbow support
to suit specic tasks. An inward position works during keyboard use, while
an outward position is recommended during mousing.
Recline Adjustment
a. Sit in the chair and ip up the lever under the left-hand side of the seat
to unlock the seat tilt. Lean back to desired position and lower the lever
to lock the seat in place.
b. To return chair back to upright position, ip the lever up and lean back until
you hear/feel a click, then sit forward.
c. Turn the crank on the right-hand side of the seat to adjust the recline tension.
Lumbar Adjustment
Adjust the depth of the lumbar support by turning the wheel located on the
back of the chair.
Headrest Height
Hold the headrest and push forward lightly, you will feel the headrest unlock,
allowing you to adjust it to your desired height.
Armrest Height
Hold armrest by the front, and pull lightly toward the back of the chair.
You will feel the arm unlock, allowing you to adjust them to your desired height.