Ursalink EM500 Series User manual

EM500 Series Quick Guide

1
1 × EM500
(Include sensor)
2 × Mounting Screws
1 × Hose Clamp
1 × Quick Guide 1 × Warranty Card

Front:
1. LoRa Antenna (Internal)
2. NFC Area
3. Waterproof Connector
（Connectors may differ according
to the sensor types）
Back:
4. Battery (Internal)
5. Wall Mounting Holes
6. Pole Mounting Holes
①
③
②
2
④
⑤
⑥

(Note: For device with external sensor only)
1. Take off the mounting bracket, remove the cap,
rubber seal and the screws on the bottom of the
device, and then take off the enclosure cover.
2. Pass the cable through the cap, rubber seal and
enclosure cover.
Install the Sensor
① ②
3

③ ④
3. Pull out the motherboard, insert and lock the
wires according to the label attached.
4. Put the motherboard back and restore
everything in its due position.
4
Power
Button

Android App:
Open “Toolbox” and attach your phone with NFC
area to the EM500 to turn it on or off.
Turn On/Off EM500 Series
1. Remove screws on the bottom of EM500 and
take off the upper case, you can find the button
beside the battery.
2. Turn on/off: Press the button for 3s to 10s
until LED blinks.
Reset: Press the button for over 10 seconds to
reset the device.
Hardware:
5

Windows Software:
Connect NFC reader to your PC, open “Toolbox”
and attach your EM500 to the NFC reader to turn
it on or off.
6
Toolbox Download:
Windows：
https://resource.ursalink.com/software/
toolbox.exe
Android：

Tel: [phone]
Web: www.ursalink.com
Email: [email protected]
7
Wall Mounting：
Pole Mounting：
Mount the EM500 Series