Vari 401551 User manual

Executive Task Chair
Patent and trademark informaon: vari.com/patents
©2022 Varidesk, LLC All rights reserved.
2 People
Recommended
Holds up to
275 lb (124.7 kg)

CHAIR BACK
x1
HEADREST
x1
x1
CHAIR SEAT
x1
PISTON
x1
BASE
x2
SCREW
x3
SPRING WASHER
x3
FLAT WASHER
x3
HEX SCREW
x1
ALLEN KEY
Parts and Tools

Align the back of the chair with the steel plate aached to the seat. Using the washers
and hex screws provided, fasten the plate to the back of the chair with the Allen key.
1
Chair Assembly
2
Remove the air piston and base from the packaging. Insert the piston into the base with
the large end down, as shown.

With assistance, ip the chair assembly onto the base assembly, lining up the hole with
the top of the piston. Using even pressure, press rmly on the seat cushion a few
mes to ensure the seat is fully engaged with the piston.
NOTE: Once assembled, do not aempt to disassemble the chair, as doing so may
damage the product.
3

Align the holes on the headrest with the holes on the back of the chair. Use the
provided Allen Key and Screws to secure the headrest. Once fastened, align and rmly
push the cover piece into place.
4

To adjust how easily the chair back reclines,
turn the knob under the front of the seat
clockwise to increase tension and counter-
clockwise to decrease tension.
Chair Adjustments
To adjust the seat height, engage the
back lever under the right side of the
seat, and adjust the seat height to the
desired seng.
To allow the chair backrest to recline,
slide the back lever under the right side
of the seat out. To prevent the backrest
from reclining, push the lever in.
To adjust the headrest’s height, gently
pull up to raise and push down to
lower.

To adjust the posion of the seat cushion,
engage the front lever under the right side
of the seat, then slide the seat forward or
backward into the desired posion.
To adjust the arm height, press
the buon under the armrest
and pull up or push down on the
armrest.
To angle the armrests or slide
armrests from front to back,
push armrests accordingly.

WARNING: To prevent injuries and product failure, do not use this chair for standing,
climbing, or leaning. Do not use if the chair is damaged or incorrectly assembled.
[phone]