
Patent and trademark informaon: vari.com/patents | ©2022, 2023 Varidesk, LLC All rights reserved. (800) 207-2587
Locate the pre-installed power cord underneath the back of the converter’s top
tray. Join the power adapter cable to the pre-installed power cord, then secure the
connecon by latching the hook. Plug the converter into an outlet.
2
4
3
With the converter plugged in, press the up arrow buon unl the converter is raised to its
highest posion, providing room to aach the keyboard tray.
Locate the 4 pre-installed handscrews below the top er. Loosen each of the handscrews, using one hand to hold one end sll while turning the other end, unl the
post in between ends is accessible. Align the notches on the keyboard tray brackets with the handscrew posts, then slide the keyboard tray into place in an up-and-
back moon. Tighten each of the handscrews to secure the tray in place.
WARNING: Do not open any of the components,
there is a danger of electric shock.
WARNING: Keep plug away from heated surfaces.
WARNING: Risk of nger injury - pinching hazard.
Use cauon when lowering desk.
WARNING: To reduce risk of re, electric shock, or
personal injury, use only indoors and do not install in a
wet or damp locaon.
WARNING: The Pro Plus™ 36 Electric is not
intended for use by young children or for
those persons who require supervision.
WARNING: Never operate this product if
it has a damaged cord or plug, is not work-
ing properly, has been dropped or damaged,
or was dropped into water. Contact our
customer service department during business
hours to report any issues.
CAUTION: Beverages such as water or
coee could cause product failure if spilled.
5
The included velcro straps
can be used to neatly gather
your cables and cords.
Supplier’s Declaraon of Conformity
47 CFR § 2.1077 Compliance Informaon
Unique Idener: 401968
Responsible Party – U.S. Contact Informaon
Varidesk, LLC
450 Freeport Parkway
Coppell, TX 75019
1-800-207-2587
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two
condions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operaon.