Vari Beam Privacy Panel 72 User manual

Beam Privacy Panel
x1
PRIVACY PANEL
5 ¾"
x2
T-BRACKETS
5 ¾"
x2
PRIVACY PANEL
ADAPTER
5 ¾"
x4
#10x1" PHILLIPS
HEAD SCREW
5 ¾"
1
Lower the privacy panel adapters into the top center channel of the Beam. To ensure the adapters are
placed properly for the panel, use a tape measure to conrm that the gap between the leg and the
adapter is 5 ¾".
5 ¾"
· PHILLIPS HEAD SCREWDRIVER · TAPE MEASURE
Tools Needed (Not Included)
Assembles in
Minutes
5 ¾"

Patent and trademark informaon: vari.com/patents
©2022 Varidesk, LLC All rights reserved. [phone]
Align one T-bracket with a privacy panel adapter and lower in place. Using a Phillips head
screwdriver and 2 of the provided screws, aach the bracket to the adapter. Repeat with the
second T-bracket, adapter, and remaining screws. NOTE: Ensure the T-brackets are vercal
and perpendicular to the Beam. If they are not, loosen the screws and adjust as needed.
2 3
Posion the panel with the predrilled holes facing down and aligned with the t-brackets,
then lower the panel onto the t-brackets.