Vertiv Remote Access Key User manual

590-1525-501A
1
Remote Access Key
Quick Installation Guide
NOTE: You will need to congure the
Avocent® AutoView™ switch for Dell
network settings at the local Setup port
for KVM remote access to function.
1. Connecting the Remote
Access Key
Connect the Remote Access Key
to any USB port on the AutoView™
switch for Dell. When the key
receives USB power, the LED on
the key will blink slowly, followed
by rapid blinking to indicate
successful enumeration, and then
illuminate continuously when the
key is accepted.
1
Dell Remote Access Key

VertivCo.com |Vertiv Headquarters, 1050 Dearborn Drive, Columbus, OH, 43085, USA
© 2017 Vertiv Co. All rights reserved. Vertiv and the Vertiv logo are trademarks or registered trademarks of Vertiv Co. All other names and logos referred to are trade names, trademarks or
registered trademarks of their respective owners. While every precaution has been taken to ensure accuracy and completeness herein, Vertiv Co. assumes no responsibility, and disclaims all
liability, for damages resulting from use of this information or for any errors or omissions. Specications are subject to change without notice.
590-1525-501A
2
Remote Access Key
Quick Installation Guide