Viavi HST-3000 User manual

Page 1 of 4
JDSU HST-3000
SAMComplete RFC-2544 and
Y.1564 Loopback
Version 1.0
February 27, 2014
Technical Support [email protected] 855-275-5378

Page 2 of 4
1. Hardware Description
The HST-3000 is a portable test tools for Ethernet testing. The product supports a variety of subscriber
interface modules (SIMs) to support Ethernet, T1/T3 and other access technologies. An Ethernet SIM
is required for this test. The HST-3000 works in conjunction with a fiber cleaning and inspection kit to
help turn-up and maintain Ethernet links. Menu selections are made from the HST-3000 front panel by
using the keypad to select the option number or by using the arrow keys to scroll to the desired
selection and pressing the OK key.
HST-3000 Front Panel:
Power Key
Second function key
Keypad
12 Buttons
Cancel Key
OK Key
Soft Keys
4 Keys
Status LEDs
LCD
Readable in
direct sunlight
Arrow keys
Microphone
Navigation Keys:
Configure, Home,
Autotest, System
Speaker
Ethernet and USB ports;
Headphone Jack
Technical Support [email protected] 855-275-5378

Page 3 of 4
User Interface:
2. HST-3000 Loopback
Use this procedure to set up an HST-3000 as a loopback device.
Step Action Details
1. Install SIM Install Ethernet Module on the HST-3000.
2. Power On Press the green Power Key to turn on the HST-3000. Wait
approximately 1 minute for the Base Unit software to load.
3. Insert SFP Insert desired SFP (1000BASE-SX, 1000BASE-LX, or 1000BASE-ZX)
into the optical SFP connector labeled R/T 1.
4. Clean & Inspect Ensure the fiber and connectors are clean using a Fiber Inspection probe.
5. Connect Connect the SFP to the Ethernet port under test.
•Use Orange Multimode jumper cables for
850 nm 1000BASE-SX.
•Use Yellow Single Mode Fiber jumper cables for
1310 nm 1000BASE-LX or 1550 nm1000BASE-ZX.
Technical Support [email protected] 855-275-5378

Page 4 of 4
6. Launch Test App Press the ETH OPTIC Soft key, select 1G Terminate, and press the
OK key. Select Layer 2 Traffic at the Test prompt
7. Configure Test Press the Configure Navigation key to configure test setting. Using the
Right Arrow key or Settings soft key, scroll through Settings menus
and configure your test as follows. Leave all other values at default,
unless specified in the Work Order.
8. View Results Press the Home key to display Summary Results.
9. Turn Laser On Press the Action soft key and select Laser On.
10. Restart Press the Restart soft key to reset test results.
11. Check LED Results Press the Right Arrow key until LED Results are displayed. A Green
Signal Present LED indicates that the HST-3000 is receiving an optical
signal from the near end Ethernet Switch. Green Sync Acquired and
Link Active LEDs indicate that the HST-3000 has successfully
connected to the near end Ethernet switch and the Ethernet link is active.
12. Test The HST-3000 is ready to be looped up.
Menu
Option
Value
Comment
Test Mode
Test
Layer 2 Traffic
.
Y.1564 Mode
Disable
SAM Complete
Disable
Link Init
Auto Negotiation
See Work Order
Set to same values as
Ethernet switch port.
Speed
See Work Order
Duplex
Full
Technical Support [email protected] 855-275-5378