Vivo DESK-V102E User manual

Electric Height Adjustable Des
Frame
Installation Manual
Email: [email protected]
Live chat: www.vivo-us.com
Call: 1-800-371-5 54
-Model DES V102E
Pacage ontents
Tools Required
phillips screwdriver, level
Scan the QR code with your mobile device or follow the link for
helpful videos and specifications related to this product.
- -https//vivo us.com/products/des v102e
1

Loosen the two screws using the
allen key (S-D). Adjust the frame
length to suit the desktop.
Retighten all screws.
Attach the telescopic crossbar to
the legs as shown, using screws (S-
A).
Assembl) Steps
Step 1 Assembling the Frame
Step 2 Installing the Side Bracets
Attach the two side
brackets (E) to both
ends of the frame using
the four screws (S-A).
Tighten all screws with
allen key (S-D).
2
Step 3 Installing the Feet
Step 4 Installing the S)nc Rod
With the frame
upside down, place
the feet (F) on the
legs as shown. Insert
the screws (S-A) and
screw them in the
desk legs using an
Allen Key.
With the frame positioned upright,
turn the knob counterclockwise to
loosen the sync rod (B). Adjust the
sync rod to match the frame’s
width.
Match the red line on the sync rod
(B) with the right side of left leg.
Match the red line on the rod of
the motor to the right side of the
right knob on the sync rod.

Step 6 onnecting the ables
Connect the the adapter (J) and the
wires attached to the leg to the
control unit (C)
Plug the adapter (J) into an outlet
on the wall after connecting it to
the control until.
M2 M1 P2 P1
Step 5 Installing the Shelf
Loosen and remove the screws
from hooks (G) with a screwdriver.
Fix the hooks to the shelf (D) with
the previously removed screws.
Tighten the screws.
Hang the shelf onto the center
part of the telescopic crossbar.
Tighten the screws.
3

4
If you do not understand these directions, or if you have
any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are
no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for
any purpose that is not explicitly specified in this manual.
We cannot be liable for damage or injury caused by
incorrect assembly or inappropriate use.
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371-5 54
For more VIVO products, check out our
website at
www.vivo-us.com.
If any parts are received damaged or defective, please
contact us. We are happy to replace parts to ensure you
have a fully functional product.
Safet) Warning
ontact us at
Last updated: 4/17/2018
Online Version
Step 7. Installing the Destop
Remove the protective film from the adhesive rubber pads (S-F). Position
the rubber pads on the side brackets as shown. Place the desktop on the
frame and insert the desktop mounting screws (S-B). Tighten all screws.
Attach the controller to the underside of the desktop using screws (S-C) as
shown. Tighten all screws. Once controller is installed, cable clips (S-E) can
be attached to the desk for cable management. Refer to Controller User
Guide for operational instructions.
Step 8. Installing the ontroller