Vivo STAND-V004F V004F User manual

  
Instruction Manual
Email: [email protected]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
-  
 
phillips screwdriver
 
1
Scan the QR code with your mobile device or follow the link
to helpful videos and specifications related to this product.
 (x4)  (x2)  (x1)  (x1)
(x1)  (x1) ! (x2) " (x4)
# (x4) $ (x3) % (x1)
3mm Alle Key
& (x1)
4mm Alle Key
 (x1)
6mm Alle Key
-  (x16)
M5x12
-   (x16)
M5x16
-  (x16)
M4x12
-   (x16)
M4x16
- (x16)
D5
-   (x16)
- -'())** +,)() *-

,./ (
( 0
Attach pole (D) to base (C) using bolts (J) and 4mm allen key (L).
( 1
Slide cable management clip (G) and arm (B) over top of pole (D) and
tighten using 6mm allen key (M).
2
( 2
Attach pole (E) to pole (D) using pole connector (F). Tighten grub
screws in pole connector using 3mm allen key (K). Slide second cable
management clip (G) and arm (B) over top of pole (E).

3
( 3
Slide VESA plates (A) onto brackets on arms (B) as shown in diagram.
( 4
Secure monitors by
placing height
adjustment knobs (H)
on square bolts and
tightening bolts (I)
through the top.
Route cables through cable management clips.
( 5
( 
( 6
Tighten arm (B) using 6mm allen key (M).
Attach VESA plates (A) to back of monitors using bolts (M-A,M-B,M-
C,M-D) and washers (M-E).
6
6.
If bolts are too long, spacers (M-F) may be required.

If you do not understand these directions, or if you have any
doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no
missing or defective parts. Improper installation may cause
damage or serious injury. Do not use this product for any
purpose that is not explicitly specified in this manual. We
cannot be liable for damage or injury caused by incorrect
assembly or inappropriate use.
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
For more VIVO products, check out our
website at
www.vivo-us.com.
If any parts are received damaged or defective, please contact
us. We are happy to replace parts to ensure you have a fully
functioning product.
-/ 7
  
Last updated: 0 /01/18
( 8
Store allen keys (K,L,M) in cable management clips (G) for future
adjustments.
( 0
Do not move monitors past center of gravity. This could result in
tipping.
9  
4