Vivo STAND-V002DU User manual

   

Instruction Manual
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
-  
 
phillips screwdriver
 
1
Scan the QR code with your mobile device or follow the link
to helpful videos and specifications related to this product.
- -!!"" #$!! "
 (x1) % (x1)  (x1)
 (x1) & (x1) ' (x1)  (x1)
( (x5) ) (x1) * (x1)
4mm
+ (x1)
5mm
-  (x4)
D5
-  (x4)
M4x12
-  % (x4)
M5x12
,

$-. 
2
 /
-/ /
-/ 
-/ -
-/ 0
Install the clamp base support (B) onto the base
of the monitor stand (A) with bolts (H) using
provided 4mm Allen wrench (J).
Secure clamp (C) to upper two holes
with bolts (H) using 4mm Allen wrench
(J) for desk with a thickness of 10-
mm.
Secure clamp (C ) to upper two holes with
bolts (H) using 4mm Allen wrench (J) for
desk with a thickness of 10-8 mm.
Attach cover (D) to base support.
 / 12
Tighten the clamp to the desktop
using the plastic knob.
-/ 3
-/- /
Slide the long screw (E)
through the top of the
grommet base support (F) and
install on base of monitor
stand with bolts (H) using 4mm
Allen wrench (J).
-/- 
Position stand on desk with
long screw through hole, and
secure by using the support
plate (I) and clamp knob (G) on
underside of the mounting
surface. NOTE: For self-drilled
installation, drill an 8. mm hole
or larger through the
mounting surface.

Remove cables covers as shown from upper and lower arms.
Replace covers making sure the cables have enough slack to
allow for free movement of the arms.
 3
 4
 
Insert screws (M-A or M-B) with washers (C) into top two holes of monitor, leaving
3mm of thread exposed. Hang monitor over slots in VESA plates. Secure monitor
with screws and washers in bottom two holes and tighten top screws.
 0
Adjust gas spring tension by turning screw with mm Allen wrench (K). Clockwise
reduces tension, counter-clockwise increases tension. The tension should be just
enough to hold your monitor in place without lifting itself up. If needed, adjust the
bolt on the side of the hinge behind the VESA plate to tighten or loosen the tilt angle
support.
3

If you do not understand these directions, or if you have any
doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no
missing or defective parts. Improper installation may cause
damage or serious injury. Do not use this product for any
purpose that is not explicitly specified in this manual. We
cannot be liable for damage or injury caused by incorrect
assembly or inappropriate use.
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
For more VIVO products, check out our
website at
www.vivo-us.com.
If any parts are received damaged or defective, please contact
us. We are happy to replace parts to ensure you have a fully
functioning product.
5. 6
  
Last updated: 04/27/18
7  
Connect USB 3.0 cables to USB ports on computer.
4