2 3
ASSEMBLY STEPS
STEP 3
Slide VESA plate with monitor onto the head of the mounting bracket, and secure with M6 cap nut (j).
PACKAGE CONTENTS
TOOLS NEEDED
WARNING!
Phillips
Screwdriver
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED
d(x1)
Allen Wrench
Set
c(x1)
VESA Plate
a(x1)
Mounting
Bracket
e(x2)
M10x45
k(x2)
M10 Nut
j(x1)
M6 Cap Nut
i(x4)
M4 Spacer
f(x2)
M10x60
b(x1)
Pole Clamp
g(x4)
M4x12
h(x4)
M4x30
Adjust tilt and swivel joints using the medium Allen wrench (d).
STEP 1
É==Ñ
Ä
~
â
Ç
STEP 2
OPTION A: Flat Back Monitor
Attach VESA plate (c) to monitor using M4x12
thumb screws. Please note, the screws only need
to be finger-tight.
OPTION B: Curved Back Monitor
Attach VESA plate (c) to monitor using M4x30
screws (h) with M4 spacers (i). Do not over-
tighten.
i
h
g
STEP 4
Install mounting bracket (a) and pole clamp (b) to
pole using M10 bolts (e, f) and M10 nuts (k). Use
M10x45 bolts (e) for smaller poles or M10x60 bolts
(f) for larger poles. Tighten with the large Allen
wrench (d).
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
22lbs
(9.97kg)
a
k
b
e. f
d
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
