Volvo Guard Alarm II User manual

Programing Guard Alarm II key code
Programing key code manually
Programing key code with programing box
All remote controls to be used with the alarm
system must be programed at the same time
(up to 4 remote controls).
Programing key codes can also be done using
the programing box as per the next
page.Programing key code with programing
box .
The programing procedure is as follows:
Shut all doors, hood (bonnet) and trunk
(boot).
-
Switch ignition on and off at least 5 times in
10 seconds.
Indicator LED should start to flash. Leave
ignition on.
Once the indicator LED starts flashing, the first
remote control must be programed within 15
seconds.
-
Press one of the buttons on one of the
remote controls.
The programing is acknowledged by the
indicator LED lighting up and staying on for
approx. 2 seconds.
The indicator LED then starts flashing for 10
seconds.
Program the other remote control within 10
seconds, i.e. while the indicator LED is
flashing.
-
-
Ignition off.
Test remote controls.
-
-
"Read new KeyCode" button
Press button A "Read new KeyCode".
Display reads, "READ NEW KEYCODE" ,
(PRESS KEY.)
-
"VCC-032946 EN 2012-08-06"
1(2)© Cop
y
ri
g
ht 2004 Volvo Car Corporation. All ri
g
hts reserved.

Press one of the buttons on all remote
controls to be programed.
Lower line of display will read "NEW CODE
OK" after each remote control has been
pressed.
Note! All old key codes will be erased when the
first remote control is programed.
-
Wait until the red light by button A "Read
new KeyCode" goes out.
-
Test all remote controls programed.
Repeat programing if any remote control does
not work.
-
"VCC-032946 EN 2012-08-06"
2(2)© Cop
y
ri
g
ht 2004 Volvo Car Corporation. All ri
g
hts reserved.