Walker Edison W70NOR User manual

P.2
General Assembly Guidelines
I. Ensure that all parts and hardware are available before beginning assembly.
II. Follow each step carefully to ensure the proper assembly of this product.
21
III. Two people are recommended for ease in the assembly of this product.
IV. The three main types of hardware used to assemble this product are : wood
dowels , screws and bolts.
V. The provided glue is to secure wood dowels in place . When first inserting dowels ,
locate the appropriate hole for the dowel , place a small amount of glue in the hole
and insert the dowel . Wipe away excess glue immediately.
In future assembly steps when dowels are necessary to attach assembly parts
together , place a small amount of glue on the end of the dowel before attaching
parts together . Wipe away excess glue immediately.
VI. A Phillips head screwdriver is required for the assembly of this product .
VII. Power tools should not be used to assemble this product .
Copyright © 2018, by Walker Edison Furniture Co., LLC. All rights reserved.

P.3
Copyright © 2018, by Walker Edison Furniture Co., LLC. All rights reserved.
Parts List
1
3
4
5
6
7
8
7
9
9
10
2
11 12
13
14
11
11 11

Attach door stopper (K) to part (1) using screw (L) with screwdrivers。
Attach cam bolt (B) to part (1) with screwdriver.

Step 4
Step 3
P.6
Copyright © 2018, by Walker Edison Furniture Co., LLC. All rights reserved.
2
3
45
6
11
11
12
11
11
A
A
A
AA
A
A
A
A
A
A
AA
A
A
A
F
F
F
G
Use hex key(G) to secure bolt (F) into part (2).
Insert wooden dowel (A) into part (3,4,5,6).

Attach part (3,4,5,6) to part (2) using bolt (E) with hex key (G)
Slide back panel (7,8) into grooves as per diagram.

Attach part (1) to part (3,4,5,6), then insert and secure cam lock (C) to part (3,4,5,6) to lock it
Attach plastic wedge (V) to part (7,8) using screw (U) with screwdriver.

Place sticker (D) over holes as per diagram.
Insert shelf support pin (H) into part(3,4,5,6).

Place shelf (9) on top of support pin .
Place plastic pivot (P) over holes as per diagram.

Attach handle (S) to part (13,14) using handle bolt (T) with screwdriver. Attach door hinge
(M,N) to part (13,14) using screw (Q) with screwdriver. Attach bolt (R) to part (13,14) with
screwdriver.
Insert top door hinge (M) into plastic pivot (P) on part (1), then slide the door (13) into
bottom hinge (N). Secure door by tightening door hinge (N) using screws (Q) with equal
pressure.

Insert top door hinge(N) into plastic
pivot (P) on part (1), then slide the door (14) into the bottom hinge (M). Secure door by
tightening door hinge (M) using screws (Q) with equal pressure.
Insert glass holder (J) into part(4,5).

Step 18
Step 17
P.13
Copyright © 2018, by Walker Edison Furniture Co., LLC. All rights reserved.
Final Assembly
10
Place glass shelf (10) on top of glass holder carefully.