Wallbeds Australia 1300 663 660 User manual

WallBeds Australia Drawer Hardware and Cabinetry Assembly Instructions
Page 1
Cam Lock Cam Pin
Hardware Parts
Euro Screw
Drawer Runners/Sides Drawer Clip
Dome Head Screw
Handle Screw Handle
Cabinetry Parts

WallBeds Australia Drawer Hardware and Cabinetry Assembly Instructions
Page 2
Cabinetry Assembly
Cam Locks – Insert all Cam Locks into the following panels - U, S, P
Drawer Runners – Attach these using the Euro screws to the side panels labelled - O-
Step 1 – Hardware Assembly
Step 2 – Drawer Cabinet Assembly
Attach the Back Panel - P- to the Side Panels – O – Cam Locks facing towards the back
Attach the Bottom Panel - S- to the Side Panels - O- Cam Locks facing down
Attach the Top Panel - U- to the Side Panels - O- Cam Locks facing down
Step 3 – Drawer Assembly
Attach the Drawer Back - R- to the Drawer Bottom - Q-
Attach the metal draw sides to the drawer bottom and drawer back panels by using the 4.5mm dome head
screws.
Hint: - The bottom edge of the drawer front is the side that has the closest measurement to the centre of the
drawer clip. See Photo 4
Starting with the bottom drawer line up the Drawer clips with the metal drawer sides. If the bottom edge of
the drawer is not in line with the bottom of the cabinet you will need to flip the drawer up the opposite way.
Once you have ascertained the drawer is the correct way up clip the drawer front – M – into the metal sides of
the drawer. Tighten the screws on the side of the draw clips. See photo 7
To adjust the gap between the drawers simply adjust by turning the Phillip’s head screw on the drawer clip.
Tip: - If you accidently clip the drawers on the wrong way see Photos 8
&
9 on how to un-clip the drawer front
from the metal drawer sides.
Cam Pins – Insert all Cam Pins into the following panels - O - and the opposite side to the cam locks in panels U
&
S
Draw Clips – Attach to the drawer front panel – M - by tapping them in with a hammer. Ensure that the
adjustable screws on the clips are facing the edge of the drawer panel.

WallBeds Australia Drawer Hardware and Cabinetry Assembly Instructions
Page 3
Step 4 – Fixing Unit together and to the Wallbed
Photo 1
Photo 2
Photo 3
Photo 4
Photo 5
Photo 6
Once the unit is assembled place it next to the side of the Alpha Bed
Important: Ensure the front edge of the drawer unit is flush with the front edge of the bed cabinet.
Place the bookshelf unit on top of the drawer unit and line up the bottom shelf with the front edge of the
drawer.
The bookshelf will then also line up with the front edge of the bed cabinet. Fix the bookshelf to the side of the
bed cabinet by using the 28mm wood screws supplied. Use an existing top shelf pin hole for this.
To attach the drawer unit to the book shelf, simply remove the top drawer & screw up into the base of the
bookshelf also using the 28mm screws supplied. You may have to pre-drill some holes.

WallBeds Australia Drawer Hardware and Cabinetry Assembly Instructions
Page 4
Photo 7
Photo 8
Photo 9