Wallbeds Australia AB-1 User manual

AB-1 Bookcase Assembly Instructions
Note: If you have two of the same cabinet each cabinet will have a different cabinet number.
Panel Stickers/Labels –Do not remove any cabinet stickers from the panels until the
units have been built, as these will assist with assembly. Most of the stickers are placed
on the “back” or underside of the cabinet and will not be seen once assembled.
AB-1 Bookcase Cabinetry Panels
1
End Panel Back Panel End Panel
Top & Bottom Panel
Kick Panel
Adjustable Shelf
©2019 WallBeds Australia

Cam Pins - Insert all Cam Locks into the following panels as described by the cabinet part
located on the cabinet sticker.
Cam Lock Cam Pin 28mm Wood Screw Shelf Pin
AB-1 Hardware Parts
Back Bottom Top
Rail
End End Bottom Top
NOTE: In the Top and Bottom
Panels insert the cam pins on the
opposite side to the Cam Lock.
Step 1– Inserting Hardware
Cam Locks – Insert all Cam Locks into the following panels as described by the cabinet part
located on the cabinet sticker.
2
©2019 WallBeds Australia

3
Step 2 - Bookcase Assembly
Start the Bookcase assembly by using either one of the Bookcase End Panels and fixing it to the
Back Panel. Ensure the cam locks on the Back Panel are not facing what will be the inside of the
Bookcase when built.
Back Panel - Place the Bookcase Back Panel onto the End Panel. Match up the cam locks with the
cam pins. Tighten the cam locks and cam pins together by using a Phillips head hand screwdriver.
Top & Bottom Panels - With the cam locks facing away from the inside of the Bookcase attach the
Bottom Panel to the End Panel and Back Panel. Repeat this process with the Top Panel. Refer to
images 1 & 2 on page 4
Place the remaining End Panel on top of the previously assembled panels. Ensuring the cam pins
are lined up with the cam locks. Tighten the cam pins to the cam locks.
Tip: You may need to lightly tap the cam pins into the cam locks with a rubber mallet. Ensure you
do this where the cam pins are. Failure to do so may result in damage to the End Panel.
Step 3 - Fixing Bookcase to the Wall Bed
You will need to pre-drill the 5mm screw holes. When attaching the cabinet to the wall bed.
These holes will be covered using the FastCaps supplied.
•Temporarily fasten the cabinets together with clamps. Pre-drill a total of four 5mm pilot holes
in the end panel of the cabinet — two towards the top of the unit and two at the bottom.
IMPORTANT – When pre-drilling wood screw pilot holes use caution not to go all the way
through to the end panel of the wall bed.
•Attach the cabinet to the wall bed using the 28mm screws supplied. Then remove the
clamps.
Caution: Do Not over tighten the wood screws into the side of the cabinet End Panel as it may
end up protruding through the opposite side of the panel.
Adjustable Shelf - Insert the shelf pins into the shelf pin holes at the desired height for your shelf.
If you find it too high or too low for the books you want to store, relocate the shelf pins to the
holes at the required height.
IMPORTANT SAFETY INFORMATION
All WallBeds Australia Bookcases and Cabinets must be securely attached to the WallBed before
use. Ensure that children DO NOT climb or hang on any part of the Bookcase Or Cabinet. Failure
to do so may result in personal injury.
©2019 WallBeds Australia

Image 2
Image 1
4
Removing Panel Stickers/Labels
Remove once installed, heat up with hair dryer & then to remove any sticky
residue use wax and grease remover or similar.
Avoid using a razor blade as you may damage the cabinetry.
©2019 WallBeds Australia