Weber iGrill 3 User manual

USER GUIDE
enUS

2iGRILL 3 |USER GUIDE
TABLE OF CONTENTS
Enhance Your Assembly
Experience
Download the free BILT™app for
step-by-step 3D instructions showing
how to install your iGRILL 3.
Before you begin
Box Contents ..........................................3
Installation ...........................................4
SPIRIT II...........................................................4
GENESIS II & GENESIS II LX ........................................12
Quick Start Instructions ..............................23
Important Information ...............................28
Intended Use .................................................... 28
Meat Probe Use.................................................. 28
Disposal Requirements .......................................... 29
Technical Specifications......................................... 29
FCC Compliance ................................................. 29
IC Compliance ................................................... 29

3iGRILL 3 |USER GUIDE
AA
+
AA
AA
+
+
Box Contents
Meat Probe
Red
Coloured
Probe
Indicator
Meat Probe
Yellow
Coloured
Probe
Indicator
Probe Wrap
WARNING!
Probe gets hot.
Use mitts.
Battery Pack
Battery Pack Bracket
iGRILL 3
AA Batteries (3)
Battery Wire
LP Magnet
LP Fuel Sensor
Probe Wrap
Wire Retention Clip

4iGRILL 3 |USER GUIDE
Installation
Remove cover plate. Some models may have screws.
1
1

5iGRILL 3 |USER GUIDE
Installation
2
Install batteries. Do not mix old and new batteries. Do not mix alkaline, standard or
rechargeable batteries.
2
-
AA
AA
AA

6iGRILL 3 |USER GUIDE
Installation
3a
Install bracket on the inside of the wheelframe. Snap battery pack into bracket.
Connect battery wire to the battery pack.
3
a) b)

7iGRILL 3 |USER GUIDE
Installation
3b
Route battery wire through front of side table. Connect battery wire to the iGRILL.
3
a) b)

8iGRILL 3 |USER GUIDE
Installation
4a
Install magnet.
4
a) b)

9iGRILL 3 |USER GUIDE
4b
Installation
Connect LP fuel sensor.
4
a) b)

10iGRILL 3 |USER GUIDE
Installation
5
Snaps into place. No screws required.
5

11iGRILL 3 |USER GUIDE
Installation
6
Remove adhesive liner from wire retention clip. Apply clip to cleansed area underneath
sidetable. Wire(s) must be secured using clip.
6

12iGRILL 3 |USER GUIDE
Installation
1
Remove cover plate. Some models may have screws - OR -
1

13iGRILL 3 |USER GUIDE
Installation
Remove LED fuel gauge.
1

14iGRILL 3 |USER GUIDE
Installation
2
Install batteries. Do not mix old and new batteries. Do not mix alkaline, standard or
rechargeable batteries.
2
-
AA
AA
AA

15iGRILL 3 |USER GUIDE
Installation
3
3
Install bracket underneath side table.

16iGRILL 3 |USER GUIDE
Installation
4
Connect the battery wire to the battery pack. Then, snap the battery pack into the bracket.
4

17iGRILL 3 |USER GUIDE
Installation
5
Route battery wire through front of side table. Connect battery wire to the iGRILL.
5

18iGRILL 3 |USER GUIDE
Installation
6a
Install magnet on GENESIS II models. GENESIS II LX models already have magnet installed.
6
a) b)

19iGRILL 3 |USER GUIDE
Installation
6b
Connect LP fuel sensor.
6
a) b)

20iGRILL 3 |USER GUIDE
Installation
7
7
Connect lighted control knob wires. Installationon GENESIS II LX only.