Yealink CP965 User manual

Introduction
The Yealink CP965 Conference Phone Supports up to 2 CPW65 DECT Microphones.
Manufacturer specifications indicate a 20m range. As the name suggests these are
Microphones only and do not include a speaker for ease of hearing at range. To use the Yealink
CPW65 your CP965 device must be on Firmware version 143.86.0.10 at a minimum.
Pairing Process
1. From the Home Screen Press the More button

2. Then press MIC.
3. Then press the Pairing Button on the CP965

4. The CP965 Conference Phone will then enter pairing mode.
5. Next, do a long press and hold of the Mute button on the CPW65 Expansion
Microphone until the light begins to rapidly flash yellow.
6. After about 10-15 seconds of flashing the devices should be in sync.

Microphone Unbinding
1. The Unbinding process should be utilized if you need to replace a microphone or have a
scenario with multiple bases sharing microphones near each other.
2. Utilize the Find feature outlined below if you are unsure which microphone is which.
3. Tap Details on the Microphone you wish to remove.

4. This page includes a variety of information about the selected microphone.

5. The unbind button is found at the bottom of Details.
6. Selecting Unbind presents you with a prompt to confirm you wish to unbind that
microphone.

7. Press OK and the microphone will become unbound allowing you to perform the pairing
process on a new microphone if required.
Microphone Find Feature
This allows a user to visually determine which Microphone is MIC1 and which is MIC2 due to
the flashing green/red Mute button.