Zest 4 Leisure Rose Round Picnic Table User manual

Assembly Instructions
2.2m (Diam) x 0.77m (H)
Item Code: Rose Round Picnic Table
PLEASE KEEP THIS INSTRUCTION
Zest4Leisure
01352 752555 option 1 –[e-mail]

Rose Round Picnic Table Assembly Instructions
Requires 2 person assembly.All screw holes to be pre-drilled.
Tools required: Corded / Cordless Drill, Pozi-drive Bit / Screwdriver, 3mm Drill Bit,
17mm Socket & Ratchet.
Rose Round Picnic Table Pack List
Item Description Quantity
A1 & A2 Seat Bar 4
B Seat Assembly 4
C Leg 8
D Leg Brace 4
E Table-Top Support 4
F Table-Top 1
Fixings
70mm Screws 16
90mm Bolt, 30mm Washer, Spring Washer & Nut 16
130mm Bolt, 30mm Washer, Spring Washer & Nut 4
130mm Bolt, 20mm Washer & Nut 12
Plastic Nut Cover 12
www.zest4leisure.co.uk

Please take a few moments to check all pack contents listed.
Please contact “Zest4Leisure” directly if any of the pack contents are damaged
or missing. Contact telephone: [phone] Option 1 or email:
[e-mail]
Assembly requires 2 persons. All screw holes to be pre-drilled.
Tools required: Hammer, Corded / Cordless Drill, Pozi-drive Bit / Screwdriver,
3mm Drill Bit, Adjustable Spanner, 17mm Socket & Ratchet.
Rose Round Picnic Table is now complete.
1. Position Seat Bars (A1) onto 2no. Seat Assemblies (B) as shown in Fig 1a, align
bolt holes and insert 130mm bolts (Fig 1b). Attach 30mm washers, spring
washers and nuts. Do not fully tighten at this stage. Repeat process using Seat
Bars A2 and remaining Seat Assemblies.
2. Position Leg (C) as shown in Fig 2a, align bolt holes and insert 2no 90 mm bolts
& attach 30mm washers, spring washers and nuts (Fig 2b). Do not fully tighten at
this stage. Repeat process for the remaining 7 legs.
3. Position Leg Brace (D) on to Seat Bars (as shown in fig 3a), and fix in position
using 2no 70mm screws. Attach Legs to Leg Brace with 2no 70mm screws. See
Fig 3b. Repeat for remaining Leg Braces.
4. Turn Assemblies over and interlock Seat BarsA1 and A2 as shown in Fig 4a &
4b.
5. Insert Table-Top Support (E), align bolt holes and insert 2no 130mm bolts (Fig 5a
& 5b). Attach Nut Cover Base (Fig 5c), 20mm washers and nuts. Do not fully
tighten at this stage. Repeat for remaining 3no Table-Top Supports.
6. Carefully locate Table-Top (F) on to Table-Top Supports, align bolt holes and
insert 4no 130mm bolts (Fig 6a & 6b). Attach Nut Cover Base, 20mm washers
and nuts as previously.
7. ALL nuts to be fully tightened at this stage and caps to be fitted to Nut Cover
Bases.

www.zest4leisure.co.uk
1b1a
2a 2b
3a 3b

www.zest4leisure.co.uk
4b4a
5a 5b
5c 5d

www.zest4leisure.co.uk
6b6a