zortrax M200 Plus Use and care manual

Manual Platform Calibration
SOURCE:
https://support.zortrax.com/manual-platform-calibration/

Table Of Content
Preparing for Calibration 3
Lifting the Platform 4
Tightening Back Screws; part 1 5
Adjusting Platform's Distance 7
Tightening Back Screws; part 2 8

Preparing for Calibration
Before starting the calibration, make sure you have tightened the three calibration
screws placed under the platform to approximately the same level.
Next, open the Tools menu, select Platform and then Manual Calibration.
The printer will lift up the platform and display the first message containing instructions
on manual calibration.

Lifting the Platform
In the first step, push the UP button until the platform is about 1 mm [0.04 in] from the
nozzle.

Tightening Back Screws; part 1
Rotate the back left screw until the platform is about 1 mm [0.04 in] from the nozzle.

Next, rotate the back right screw until the platform is about 1 mm [0.04 in] from the
nozzle.

Adjusting Platform's Distance
Prepare the piece of paper and place it between the platform and the nozzle. Next,
adjust the platform’s distance using the UP/DOWN buttons until you feel slight
resistance when moving the paper.

Tightening Back Screws; part 2
Rotate the back left screw until you feel slight resistance when moving the paper.

Next, rotate the back right screw until you feel slight resistance when moving the paper.
Powered by TCPDF (www.tcpdf.org)