zortrax M200 Plus Use and care manual

Perforated Plate Replacement
SOURCE:
https://support.zortrax.com/m200-plus-perforated-plate-replacement/

Table Of Content
Unplugging the Power Cable 3
Unplugging the Heatbed Cable (from the Z-axis Cover) 4
Platform Removal 5
Unplugging the Heatbed Cable (from the Platform) 6
Unscrewing the Perforated Plate 7
Cleaning the Heatbed 8
Securing the Perforated Plate 9
Platform Installation 10
Plugging the Heatbed Cable (into the Z-axis Cover) 11
Plugging the Power Cable 12

Unplugging the Power Cable
Turn off the printer and unplug the power cable.

Unplugging the Heatbed Cable (from the Z-axis
Cover)
Unplug the heatbed cable from the Z-axis cover.

Platform Removal
Remove the platform with the heatbed cable from the printer.

Unplugging the Heatbed Cable (from the
Platform)
Unplug the heatbed cable from the platform.

Unscrewing the Perforated Plate
Unscrew the screws to separate the perforated plate from the heatbed.

Cleaning the Heatbed
Remove material remains from the heatbed using a piece of cloth or, if it is necessary,
use a spatula.

Securing the Perforated Plate
Secure the new perforated plate to the heatbed with the screws.

Platform Installation
Place the heatbed cable behind the heatbed mount and install the platform back in the
printer.

Plugging the Heatbed Cable (into the Z-axis
Cover)
Plug the heatbed cable into the Z-axis cover.

Plugging the Power Cable
Plug the power cable in.
Powered by TCPDF (www.tcpdf.org)