zortrax DSS User manual

Unpacking & First Use
SOURCE:
https://support.zortrax.com/dss-unpacking-first-use/

Table Of Content
In the Box 3
Unpacking 4
Setting up 6
Operating 10

In the Box
The graphic shows the whole box content.

Unpacking
Open the box and remove the cushioning.
Use the handles to take the Zortrax DSS station out of the box. The handles are on both

sides of the housing.
Remove the security foil.
The box also contains: rubber gloves, brush, drain pipe, quick start guide, rinsing basket.

Setting up
Remove the top cover.
Remove the rinsing basket.

Make sure that no foils or other elements are inside the device.
Put the model in the rinsing basket.

Carefully place the basket inside the device.
Fill up the device with warm water.
Do not fill the device all the way to the top. Make sure that the water level is above the
model.

Put the top cover back into place.

Operating
Plug in the power cable and turn on the device.
Press the POWER ON switch. Set the temperature and time with the buttons on the