Zte MF833V User manual

Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com
MF833V
USB Modem
Quick Start Guide

LEGAL INFORMATION
Copyright © 2018 ZTE CORPORATION.
All rights reserved.
No part of this publication may be excerpted, reproduced, translated or utilized in any form or by
any means, electronic or mechanical, including photocopying and microlm, without the prior written
permission of ZTE Corporation.
The manual is published by ZTE Corporation. We reserve the right to make modications on print
errors or update specications without prior notice.
Version No. : R1.0
Edition Time: February 2, 2018
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com

Getting to Know Your Modem
Your modem supports data service through the mobile phone network.
The following gure is only for your reference. The actual product may be different.
1. Modem cap
2. Front cover
3. Indicator light
4. USB connector
5. micro-SIM card slot
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com

Installing the micro-SIM Card
1. Press and push the front cover and remove it.
NOTE:
Open the front cover carefully. Failing to do so may cause damage to the
front cover.
2. Insert a micro-SIM card to the micro-SIM card slot.
WARNING!
Your modem does not support SIM cards and nano-
SIM cards. To avoid damage to the modem, do not
use those cards or any card holders.
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com

3. Slide the front cover gently back into place.
Connecting the Modem to Your Device
Insert the modem into your device’s USB port securely. After the MF833V is connected to the
device successfully, your device can access the Internet.
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com

Status Indicator Light
Color Description
No light Airplane/Standby mode
Red solid Booting up, searching for a network, no micro-SIM card, or no network
service.
Green solid Registered to a 2G/3G mobile network.
Green blinking Connected to the 2G/3G mobile network and data is being transferred.
Blue solid Registered to a 4G mobile network.
Blue blinking Connected to the 4G mobile network and data is being transferred.
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com

Warning and Notice
Using Your Modem
• If inadequately shielded, some electronic devices may be affected by the electromagnetic
interference caused by the modem, such as the electronic system of vehicles. Consult the
manufacturers of such devices before using the modem if necessary.
•Operating the modem may interfere with medical devices such as hearing aids and
pacemakers. Always keep the modem more than 20 centimeters away from such medical
devices when your modem is turned on. Turn the modem off if necessary. Consult a
physician or the manufacturers of medical devices before using the modem if necessary.
•Be aware of the usage limitation when using the modem at places such as oil warehouses or
chemical factories, where there are explosive gases or explosive products being processed.
Turn off the modem if necessary.
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com

• Do not use electronic transmission devices in aircrafts, at petrol stations or in hospitals.
Observe and obey all warning signs, and turn off the modem in these conditions.
•Do not touch the inner antenna area unless it is necessary. Otherwise the performance of the
modern may be affected.
•Keep the modem out of the reach of children to prevent injury.
•When the modem is operating, do not touch the metallic parts. Failing to do so may cause
burns.
•Use original accessories or accessories that are authorized. Using any unauthorized
accessories may affect the performance of the modem and violate the related national
regulations about telecom terminals.
•Avoid using the modem near or inside metallic structures or establishments that can emit
electromagnetic waves, because signal reception may be affected.
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com

• The modem is not waterproof. Keep the modem dry and store it in a shady and cool place.
• Do not use the modem immediately after a sudden temperature change. In such case, dew
may be generated inside and outside the modem, so do not use it until it becomes dry.
• Handle the modem carefully. Do not drop, bend or strike it. Otherwise the modem may be
damaged.
• Only qualied personnel can dismantle and repair the modem.
• An operating temperature between -10°C and +55°C and a humidity between 5% and 95% are
recommended.
Limited Warranty
• This warranty does not apply to defects or errors in the product caused by:
i. Reasonable abrasion.
ii. End users’ failure to follow ZTE’s installation, operation or maintenance instructions or
procedures.
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com

iii. End users’ mishandling, misuse, negligence, or improper installation, disassembly, storage,
servicing or operation of the product.
iv. Modications or repairs not provided by ZTE or a ZTE-certied individual.
v. Power failures, surges, re, ood, accidents, and actions of third parties or other events
outside ZTE’s reasonable control.
vi. Usage of third-party products, or usage in conjunction with third-party products if such
defects are due to the combined usage.
vii. Any other cause beyond the range of normal usage intended for the product.
End users have no right to reject or return the product, or receive a refund for the product from ZTE
under the above-mentioned situations.
• This warranty is end users’ sole remedy and ZTE’s sole liability for defective or nonconforming
items, and is in lieu of all other warranties, expressed, implied or statutory, including but not
limited to the implied warranties of merchantability and tness for a particular purpose, unless
otherwise required under the mandatory provisions of the law.
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com

Limitation of Liability
ZTE shall not be liable for any loss of profits or indirect, special, incidental or consequential
damages resulting from or arising out of or in connection with using of this product, no matter
whether or not ZTE had been advised, knew or should have known of the possibility of such
damages, including, but not limited to lost prots, interruption of business, cost of capital, cost of
substitute facilities or product, or any downtime cost.
Solid State Supplies Ltd
[phone] | [email protected] | www.sssltd.com