Aaeon AEC-VPMS-200 User manual

Power Management Kit AEC-VPMS-200
AEC-VPMS-200
Power Management Kit
for BOXER Series
DC 12V Input and Output
AEC-VPMS-200 Manual 2nd Ed
June 2008

Power Management Kit AEC-VPMS-200
i
Copyright Notice
This document is copyrighted, 2008. All rights are reserved. The
original manufacturer reserves the right to make improvements
to the products described in this manual at any time without
notice.
No part of this manual may be reproduced, copied, translated,
or transmitted in any form or by any means without the prior
written permission of the original manufacturer. Information
provided in this manual is intended to be accurate and reliable.
However, the original manufacturer assumes no responsibility
for its use, or for any infringements upon the rights of third
parties that may result from its use.
The material in this document is for product information only
and is subject to change without notice. While reasonable
efforts have been made in the preparation of this document to
assure its accuracy, AAEON assumes no liabilities resulting
from errors or omissions in this document, or from the use of the
information contained herein.
AAEON reserves the right to make changes in the product
design without notice to its users.

Power Management Kit AEC-VPMS-200
ii
Acknowledgments
All other products’ name or trademarks are properties of their
respective owners.
 Award is a trademark of Award Software International, Inc.
 CompactFlash™ is a trademark of the Compact Flash
Association.
 Microsoft Windows®is a registered trademark of Microsoft Corp.
 ITE is a trademark of Integrated Technology Express, Inc.
 PC/AT, PS/2, and VGA are trademarks of International Business
Machines Corporation.
All other product names or trademarks are properties of their
respective owners.

Power Management Kit AEC-VPMS-200
iii
Packing List
Before you begin installing your card, please make sure that the
following materials have been shipped:
• 1 AEC-VPMS-200
• 1 Power Cord to Controller
• 1 Power Cord to Battery
• 1 Power Cord to ACC
• 1 CD-ROM for manual (in PDF format)
If any of these items should be missing or damaged, please
contact your distributor or sales representative immediately.

Power Management Kit AEC-VPMS-200
iv
Attention
1. This vehicle use POWER MANAGEMENT UNIT has the
function of detecting input voltage automatically
2. If the POWER MANAGEMENT UNIT cannot be turned on,
please check the situations below:
 check if the vehicle starts.
 check if the battery voltage is too low.
 check if the connector part for wiring is abnormal. If
all parts is normal, please hand it over to AAEON
dealer to solve the problem.
3. The POWER MANAGEMENT UNIT activates the function
of low voltage protection and it will stop the output.
4. If the POWER MANAGEMENT UNIT has fume, please
disconnect the connectors to the charger and battery
immediately, and contact with AAEON responsible sales to
solve the problem.
5. The unit is intended to install in a temperature-controlled,
indoor area free of conductive contaminants.
6. A battery can present a risk of electric shock and high short
circuit current. The following precaution should be
observed when working on batteries:
 Remove watches, rings or other metal objects
 Use tools with insulated handles
 Wear rubber gloves and boots
 Do not lay tools or metal parts on the tope of
batteries
 Disconnect charging source prior to connect or
disconnect battery terminals
7. If you find outer covering of the POWER MANAGEMENT

Power Management Kit AEC-VPMS-200
v
UNIT has unusual high-temperature phenomenon, please
hand it over to the dealer.
8. If there is any questions, please contact with AAEON dealer
or service center.
Procedures of turning on the POWER MANAGEMENT UNIT:
1. First of all, connecting the recharged connector of the
POWER MANAGEMENT UNIT to charger in vehicle.
2. Connecting battery connector of the POWER
MANAGEMENT UNIT to vehicle battery, and the POWER
MANAGEMENT UNIT will be turned on automatically.
3. The POWER MANAGEMENT UNIT begins to output
voltage and LED indicators will be illuminated in green 10
seconds later.
Note: the delay time of output voltage is adjustable and the
default is 10 seconds.
4. If the green LED of the POWER MANAGEMENT UNIT
does not illuminated in 10 seconds, it means that the
POWER MANAGEMENT UNIT works abnormally.
Please refer to the bullet 2 of Attention for troubleshooting.
Function explanation:
1. Before you start up the POWER MANAGEMENT UNIT,
you have to connect the vehicle battery and generator first.
Make sure all cables have been connected properly. The
POWER MANAGEMENT UNIT will be turned on

Power Management Kit AEC-VPMS-200
vi
automatically and output 12V± 3V voltage.
2. Green LED illuminated steady and it means the POWER
MANAGEMENT UNIT operates normally. If the green
LED flashes, it shows the POWER MANAGEMENT UNIT
is in battery supply mode.
3. If the loading exceeds 133% of nominal value for 3
seconds, the overload protection will be activated to stop
output.

Power Management Kit AEC-VPMS-200
vii
Safety & Warranty
1. Read these safety instructions carefully.
2. Keep this user's manual for later reference.
3. Disconnect this equipment from anyAC outlet before cleaning.
Do not use liquid or spray detergents for cleaning. Use a damp
cloth.
4. For pluggable equipment, the power outlet must be installed
near the equipment and must be easily accessible.
5. Keep this equipment away from humidity.
6. Put this equipment on a reliable surface during installation.
Dropping it or letting it fall could cause damage.
7. The openings on the enclosure are for air convection. Protect
the equipment from overheating. DO NOT COVER THE
OPENINGS.
8. Make sure the voltage of the power source is correct before
connecting the equipment to the power outlet.
9. Position the power cord so that people cannot step on it. Do
not place anything over the power cord.
10. All cautions and warnings on the equipment should be noted.
11. If the equipment is not used for a long time, disconnect it from
the power source to avoid damage by transient over-voltage.
12. Never pour any liquid into an opening. This could cause fire or
electrical shock.
13. Never open the equipment. For safety reasons, only qualified

Power Management Kit AEC-VPMS-200
viii
service personnel should open the equipment.
14. If any of the following situations arises, get the equipment
checked by service personnel:
 The power cord or plug is damaged.
 Liquid has penetrated into the equipment.
 The equipment has been exposed to moisture.
 The equipment does not work well, or you cannot get it
to work according to the users manual.
 The equipment has been dropped and damaged.
 The equipment has obvious signs of breakage.
15. DO NOT LEAVE THIS EQUIPMENT INAN ENVIRONMENT
WHERE THE STORAGE TEMPERATURE IS BELOW -20° C
(-4°F) OR ABOVE 60° C (140° F). IT MAY DAMAGE THE
EQUIPMENT.
FCC
This device complies with Part 15 FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received including interference that may cause
undesired operation.
Caution:
It may cause danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.

Power Management Kit AEC-VPMS-200
ix
Below Table for China RoHS Requirements
产品中有毒有害物质或元素名称及含量
AAEON Boxer/ Industrial System
有毒有害物质或元素
部件名称 铅
(Pb)
汞
(Hg)
镉
(Cd)
六价铬
(Cr(VI))
多溴联苯
(PBB)
多溴二苯醚
(PBDE)
印刷电路板
及其电子组件 ×○○○○○
外部信号
连接器及线材 ×○○○○○
外壳 ×○○○○○
中央处理器
与内存 ×○○○○○
硬盘 ×○○○○○
电源 ×○○○○○
O：表示该有毒有害物质在该部件所有均质材料中的含量均在
SJ/T 11363-2006 标准规定的限量要求以下。
X：表示该有毒有害物质至少在该部件的某一均质材料中的含量超出
SJ/T 11363-2006 标准规定的限量要求。
备注：
一、此产品所标示之环保使用期限，系指在一般正常使用状况下。
二、上述部件物质中央处理器、内存、硬盘、电源为选购品。

Power Management Kit AEC-VPMS-200
x
Contents
Chapter 1 General Information
1.1 Introduction................................................................1-2
1.2 Features....................................................................1-4
1.3 Specifications............................................................1-5
Chapter 2 Quick Installation Guide
2.1 Dimension .................................................................2-2
2.2 System Connection Diagram ....................................2-3
2.3 Delay Timer Setting...................................................2-4

Power Management Kit AEC-VPMS-200
Chapter 1 General Information 1- 1
General
Chapter
1
Information

Power Management Kit AEC-VPMS-200
Chapter 1 General Information 1- 2
1.1 Introduction
AEC-VPMS-200 is an intelligent 12V DC Vehicle Power
Management Unit designed for car, boat, and electric cart, etc
applications such as mobile DVR. It will prevent system damage
from power surges and eliminate battery drain AEC-VPMS-200
provides the following features:
 Input Range 12V DC
 12V DC outputs for 72W (12V/8A; Input 12V DC)
 Low Battery Protection (Battery Voltage under 83% (DC
10V) of output)
Delay On/Off Time setting (1sec – 30 mins, Adjustable by
on-board jumper)

Power Management Kit AEC-VPMS-200
Chapter 1 General Information 1- 3
1.3 Specifications
System
 Watt 72W
 Input Voltage DC 12V
Mechanical and Environmental
 Construction Aluminum Alloy Chassis
 Color Black
 Mounting Wallmount (Default)
 Dimension 5.24”(W) x 4.07”(L) x
1.38”(H) (133mm x 103.4mm x
34mm)
 Net weight 0.374 lb (170g)
 Gross weight 1.1 lb (500g)
 Operating Temperature 5℉~140℉(-15℃~60℃)
 Operating Humidity 5~90%@40℃, non-condensing
 EMC CE/FCCClassA

Power Management Kit AEC-VPMS-200
Chapter 1 General Information 1- 4
1.4 I/O
Front
ATX 12V
SYSL.B
Back
BAT ACC Timer

Power Management Kit AEC-VPMS-200
Chapter 2 Quick Installation Guide 2-1
Quick
Installation
Chapter
2
Guide

Power Management Kit AEC-VPMS-200
Chapter 2 Quick Installation Guide 2 - 2
2.1 Dimension

Power Management Kit AEC-VPMS-200
Chapter 2 Quick Installation Guide
2 - 3
2.2 System Connection Diagram
Battery in
ACC in
DC output

Power Management Kit AEC-VPMS-200
Chapter 2 Quick Installation Guide 2 - 4
2.3 Delay Timer Setting
Never
Never
5 mins
5 min
10 mins
10 min

Power Management Kit AEC-VPMS-200
Chapter 2 Quick Installation Guide
2 - 5
20 mins
20 min
30 mins
30 min