ADLINK Technology USB-2405 User manual

USB-2405 Quick Start Guide Rev. 2.00
USB-2405
4-CH 24-Bit 128kS/s Dynamic Signal Acquisition USB 2.0 Module
Getting Started
Package Contents
Your package should contain:
• Rail mount kit
• ADLINK All-in-One CD
• Quick Start Guide
(this document)
• USB-2405
• Stand
• USB cable (2m)
P/N 50-40230-5000 Aug. 23, 2013
Features
Installing the Driver
• Hi-Speed USB 2.0
• USB bus powered
• 24-bit Sigma-Delta ADC with
built-in anti-aliasing filter
• 4-CH simultaneous sampling
analog input, up to 128kS/s
• AC or DC input coupling,
software selectable
• Analog or digital triggering
• Supports 2mA excitation output on
each analog input channel for
IEPE sensor measurement
• Full auto-calibration
• Ready-to-use testing application
(U-Test) provided
1. Download the latest UD-DASK driver & U-Test from:
http://www.adlinktech.com/
and run.
2. Follow the installation instructions
Check Product Package
Install USB-2405 driver
(UD-DASK)
& utility (U-Test)
Connect USB-2405
to USB 2.0/3.0 port
Perform quick test
with U-Test
utility

USB-2405 Quick Start Guide Rev. 2.00
P/N 50-40230-5000 Aug. 23, 2013
Advance Technologies
Automate the World
Web: http://www.adlinktech.com
Service: [e-mail]
Tel: [phone]
Fax: [phone]
Copyright 2013 ADLINK Technology, Inc.
Contents and specifications subject to change
without notice.
Contact ADLINK
Connecting the USB-2405
1. Connect the USB-2405 module to one USB 2.0 or 3.0 port on the computer
using the included USB cable
2. The first time the USB-2405 module is connected, a New Hardware message
appears. It will take around 6 seconds to load the firmware. When complete,
the LED indicator on the rear of the USB DAQ module changes from amber
to green and the New Hardware message closes.
The USB-2405 module can now be located in the hardware Device Manager,
as shown.
I/O, Mounting, & Connectivity Quick Testing with U-Test
1. Connect IEPE sensors (microphone or accelerometer) to the USB-2405
2. Launch the U-Test Utility from either the Start menu, or
C:\ADLINK\U-test\U-Test.exe
3. Once the connected USB-2405 is detected automatically, configure the
necessary channel settings and run to implement quick testing