Anova BRP101 User manual

anovafurnishings.com
888.535.5005 tel
ASSEMBLY INSTRUCTIONS
BRP101 Loop Bike Rack
BRP102 Hoop Bike Rack
TOOLS NEEDED
9/16” Open-end or Box-end Wrench•
Ratchet with 9/16” Socket•
16 x
3/8”
Flat Washer
8 x
3/8”
Hex Nut
8 x
3/8” X 1.5”
Hex Head Bolt
ASSEMBLY:
NOTE: Before assembling the Nuts to the Bolts, it is recommended that a light oil or petroleum jelly be applied to the Bolt threads.
1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.
2. Place the Inner Rack on the packaging cardboard or other so surface. Position one of the Rack Ends near one end of the Inner
Rack.
3. Align the mounting holes in the bracket on the Rack End underneath the mounting holes at the end of the Inner Rack. Install a
Flat Washer onto one of the 1.5” long Bolts and insert the Bolt through both parts, with the Bolt head on the top surface of the
Inner Rack. Install a Washer and Hex Nut on the end of the Bolt.
Leave the hardware nger tight so that adjustments can be made.
Install a Bolt and Washer through the other set of mounting holes in that end of the Inner Rack and Rack End bracket and
install a Washer and Nut. Tighten the hardware.
ASSEMBLY HARDWARE:
BENCH COMPONENTS:
2 x
Rack End
Nut
Flat Washer
Hex Head Bolt
Flat Washer
1.5” Long Bolt
and Flat Washer
Model BRP101 shown.
Inner Rack design may vary.
1 x
Inner Rack
(Hoops or Loops)
Packaging cardboard
or other so surface
OR
Flat Washer
and Nut
Inner Rack
Rack End

Do not drag the assembled unit across any surface.•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to•
remove surface dirt. Do not clean with a solvent or petroleum based products.
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,•
missing, or broken hardware, and general instability.
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.•
Repairs must be made using only factory authorized parts and methods.•
WARNING
CARE AND
MAINTENANCE
211 North Lindbergh Blvd.
St. Louis, MO 63141
tel: [phone]
web: anovafurnishings.com
10/2012
1.5” long Bolt
and Flat Washer
Flat Washer
and Nut
Packaging cardboard
or other so surface
4. Attach the other Rack End to the other end of the Inner Rack in the same manner, installing the 1.5” long Bolts from the top.
Tighten the hardware aer both Bolts are installed.
5. Retighten all hardware two weeks aer initial assembly.