AnyTone D578UV Use and care manual

D578UV Mobile Radio
Firmware Update Instructions
*Note: Once the radio is put in the FW update mode you must complete the FW
Update Write to prevent the radio from staying in the Update Mode **
1.) Power the radio "ON".
2.) Press and Hold both the MENU and EXIT keys.
Now power the radio "OFF"
3.) The red LED li ht should now blinkin , and the radio has entered into firmware update
mode.
4.) Use the USB cable to connect radio to your PC.
5.) Open the radio Computer Pro rammin Software (CPS) and o to TOOLS > Firmware
Update
6.) Select the Open File button and select the appropriate D578UV.spi file in the FW Update
folder
7.) Check and Set the Com Port that is correct for your PC connected to the radio.
8.) Select the rite button to write the new FW to the radio.
9.) After the firmware update is finished, you must perform a Reset of the Radio (MCU
Reboot).

D578UV Mobile Radio
Firmware Update Instructions
Radio Reset / MCU Reboot
1) To Reset the Radio: Press and Hold the two front panel keys P2 and the Channel Knob
(the one above the microphone connector) Hold these two keys while turnin on the radio
and it will reboot the radio into the Reset Mode.
2) The radio Reset Screen will appear and ask you to Confirm the reset by pressin the Menu
key on the front panel. The reset itself will take a minute or more.
3) After completin the reset, the Calibration Date settin s screen will open. You need to set the
correct information by usin the Channel Knob. Pushin the Channel Knob will navi ate throu h the
GMT, Date and Time fields, Rotatin the Channel Knob will allow you to chan e the settin s. When
finished settin the data, use the Menu button to Confirm and the radio will reboot.
4) After successfully resettin the radio, your codeplu will be one and the factory smaller version
loaded. You should now load your saved Code Plu into the radio. Check the Com Port, and from the CPS
write your codeplu into the radio. No special set-up is required to write a codeplu into the radio.
http://tiny.cc/AnytoneDMR

If the radio does not let you do a MCU Reset.
ou need to turn it on in the CPS.
See how below.
Also make sure Power-on Password is turned off
CPS - Optional Settings - Power on
Startup Reset = ON
Save Codeplug
Now Send codeplug to radio
Follow instruction as above in second part off this document.
http://tiny.cc/AnytoneDMR