Argos 496/1932 User manual

Assembly Instructions - Please keep for future reference 496/1932
Dimensions
Width - 120cm
Depth - 40cm
Height - 39.5cm
Important
Version 1 Date: 12/10/15
Storage Bench
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
- Please read these instructions fully before starting assembly

1
Safety and Care Advice
Important –Please read these instructions fully before startingassembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
Handy Hints
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.

Components - Panels
Please check you have all the panels listed below
If you have damaged or missing components, call the
Customer Helpline:
Argos = 0345 6400800
2
Front panel (110.4 x 34.9cm)
1
Back panel (110.4 x 34.9cm)
2
Top panel (120.1 x 40.1cm)
3
Bottom panel (110.4 x 34.8cm)
4
Right side panel (29.5 x 34.8cm)
6
Front left leg
(37.7 x 5.1cm)
7
Front right leg
(37.7 x 5.1cm)
8
Back left leg
(37.7 x 5.1cm)
9
Left side panel (29.5 x 34.8cm)
5
Pilot holes for
guidance only
Pilot holes for
guidance only
Pilot holes for guidance only
Pilot holes for guidance only
Back right leg
(37.7 x 5.1cm)
10

A B C
D E F
3
Ruler - Use this ruler to help correctly identify the screws
Tools required
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Drill
Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
The screws length is measured from the head to the point (30mm screw shown).
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
Components - Fittings
15mm Locking nut x 14
65mm Screw x 8 14mm Screw x 1012mm Screw x 18
39mm Locking pin x 14 30mm Dowel x 12
G H I
Screw cover x 8 Hinge x 3
Foot x 1
J K
Left spring hinge x 1 Right spring hinge x 1

4
Assembly Instructions
Step 1
Fitting the left side and
right side panels
b:
a:
c:
b: Insert Dowels into
the Left side panel
and Right side panel .
F
5
6
c: Carefully locate the
Front left leg , Back left
leg , Back right leg
and Front right leg onto
the Left side panel and
Right side panel .
7
910
8
6
5
Insert 8 Locking nuts
into the Left side panel
and Right side panel .
E
Use a screwdriver to turn
Locking nuts clockwise
to lock.
E
5
6
a: Screw Locking pins
into the Front left leg ,
Back left leg , Back
right leg and Front
right leg .
D
7
9
10
8
Note:
Insert Locking pins
as far as shown.
Do not over tighten.
D
DD
D
D
DD
D
F F
F
E
E
E
E
E
E
E
E
F
D
E
7
8
9
10
9
7
5 6
6
5
10
8

Continued on next page.
Assembly Instructions
Step 2
5
b:
a:
a: Insert Dowels into
the Bottom panel .
F
4
c:
c: Carefully locate the
Bottom panel onto the
Back panel .
4
2
Insert 3 Locking nuts
into the Bottom panel .
E
Use a screwdriver to turn
Locking nuts clockwise
to lock.
E
4
b: Screw Locking pins
into the Back panel
and Front panel .
D
2
1
Note:
Insert Locking pins
as far as shown.
Do not over tighten.
Use Screws to fix Foot
onto the
Bottom panel
.
C
H
4
Attaching front, bpttom
and back panels
D
D
D
D
D
D
F
C
H
F
F
F
F
F
F
F
E
E
E
C
H
D
4
2
4
1
2
E

6
Assembly Instructions
Step 2 - continued
d:
Step 3
Attaching left side and
right side panels
Use 8 Screws to fix
Left side panel and
Right side panel onto
the unit.
A
5
6
Use Screws covers to
cover the screw heads.
G
d: Carefully locate the
Front panel onto the
Bottom panel .
1
4
Insert 3 Locking nuts
into the Bottom panel .
E
Use a screwdriver to turn
Locking nuts clockwise
to lock.
C
4
With help, ask
someone to hold
the
Front panel .
1
E
G
A
G
A
G
A
G
A
GA
GA
GA
GA
E
E
E
1
2
5
6
4
1
4
2

Assembly Instructions
7
a:
Step 4
b:
b: Use Screws to fix the
Hinges onto the Back
panel .
Attaching top panel
a: Use Screws to fix
the Hinges onto the
Door panel .
3
B
I
2
B
I
Continued on next page.
With help, ask
someone to hold
the Door panel .
3
B
B
B
3
2
B
I
B
IB
3
I
I
I
B
B
I
II
I
B
B
B
B

8
Assembly Instructions
Step 4 - continued
d:
c:
d: Use Screws to fix
the Left spring hinge
and Right spring hinge
onto the Door panel .
3
C
J
K
c: Use Screws to fix
the Left spring hinge
and Right spring hinge
onto the Left panel and
Right panel .
6
5
C
J
K
K
J
C
C
C
J
C
K
K
C
3
2
5
6
3
2
C
C
K
J

Assembly Instructions
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Assembly is complete.
Step 5
Finishing the unit
Note:
It would be useful
to ask someone to help
you at this stage.
With help, place the unit
in the intended position.
9