Argos COLOURMATCH BARSTOOL 600/6060 User manual

Important - Please read these instructions fully before starting assembly
COLOURMATCH BARSTOOL
Assembly Instructions - Please keep for future reference
Dimensions
Width - 38.5cm
Depth - 40cm
Height - 64-86cm
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Issue 4 - 15/10/12
600/6015
600/6060
600/6008
600/5982
600/5975
600/5999

1
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Warnings
Care and maintenance
• Do not stand on the chair.
• Do not use the chair as a step
ladder.
• Do not sit with sharp objects in
back pockets as this may
damage the seat surface.
• Do not knock the surface of
the seat against sharp solid
surfaces.
• Please clean the table surface
using either damp (not wet)
cloth and a mild domestic soap
solution or by using an
appropriate polish.
• Do not use any abrasive
materials when cleaning.
• From time to time check that
there are no loose bolts on this
unit.
• At least 2 people are required
to assemble this product.
• Do not discard any of the
packaging until you have
checked that you have all the
parts and the pack of fittings.
• Assemble this product on a flat
protected surface.
• Assemble all parts loosely
before tightening any bolts.
• Discard all extra fittings and
keep fittings out of reach of
children.
• Maximum safe weight of user:
110kgs.
• Unit weight: 5.5 kgs.
• Dispose of all packaging
carefully and responsibly.
• Retain assembly instruction for
future reference.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.

2
Please check you have all the parts listed below
1Seat
(38.5 x 37 x 46cm)
2Gaslift
(Ø5 x 49-71cm)
3Footrest
(33.5 x 20 x 3.5cm)
4Decor ring
(Ø5 x 7.5 x 2cm)
5Base
(Ø38.5 x 8.5cm)
Components - Parts If you have damaged or missing components,
call the Customer Helpline: 08456 400800
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
AB
Stud bolt x 1
Components - Fittings
Allen key x 1

Step 3
3
Assembly Instructions
Step 1
Step 2
Attaching gaslift
Attaching footrest
Lay the seat upside
down onto a protected
surface. Fix the footrest
onto the seat and
tighten by turning in
counter-clockwise
direction.
Place the base on a
flat protected surface.
Position the decor ring
on the base and
insert the gaslift into
the decor ring and hole
of the base.
Important:
Remove plastic tip
cover on
gaslift before
assembling.
3
5
5
4
4
1
2
2
1
3
Please remove
Plastic tip

Step 3
4
Attaching the seat
Insert the gaslift into
the seat . Secure by
pressing down the seat
firmly.
1
2
Adjust the footrest and
make sure to centre align
it with the seat. Then
secure using stud bolt
as shown and tighten
using allen key .
A
B
Securing footrest
Lever
Assembly Instructions
Step 3
Step 4
Gaslift operation
Assembly is complete.
To adjust the seat higher,
lift up the lever under the
seat and release at
desired height.
To lower the seat, lift up
the lever while fully
seated on the stool.
To ensure proper operation
of the gaslift, a person
must sit fully on the seat.
Sitting on the tip or edges
of the seat may not
activate the gaslift properly.
2
1
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
A
B
3
3
3
A