Argos 389/6039 User manual

Assembly Instructions - Please keep for future reference
-
389/6039
Dimensions
Width - 92cm
Depth - 39.5cm
Height - 48cm
Important
Version 1 Date: 27/04/15
Corner TV Unit with 2 Doors
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
- Please read these instructions fully before starting assembly

1
Safety and Care Advice
Important –Please read these instructions fully before startingassembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
Handy Hints
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.

Components - Panels
Please check you have all the panels listed below
If you have damaged or missing components, call the
Customer Helpline:
Argos = 0345 6400800
2
Top panel (92 x 39cm)
1
Bottom panel (92 x 39cm)
2
Middle Left panel
(37.1 x 37.1cm)
3Middle right panel
(37.1 x 37.1cm)
4
Right panel
(37.1 x 19.2cm)
6
Right door panel
(35.2 x 20cm)
8
Middle shelf panel (48 x 37cm)
9
Shelf panel x 2 (18.8 x 14.5cm)
10
Front panel (82 x 6cm)
11
Left side support (16.5 x 6cm)
12
Door support x 2 (18.8 x 2.5cm)
14
Large back panel (50.3 x 40cm)
15
Left panel
(37.1 x 19.2cm)
5
Left door panel
(35.2 x 20cm)
7
Small back panel x 2
(37.1 x 19.5cm)
16
Right side support (16.5 x 6cm)
13
Pilot holes for
guidance only
Pilot holes for
guidance only
Pilot holes for
guidance only
Pilot holes for
guidance only
Pilot holes for
guidance only
Finished front edge

A B C
D
G
E F
3
Ruler - Use this ruler to help correctly identify the screws
Tools required
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Drill
Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
The screws length is measured from the head to the point (30mm screw shown).
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
Components - Fittings
H
14mm Screw x 8
30mm Dowel x 6 40mm Screw x 450mm Screw x 14
43mm Locking pin x 8
Door hinge x 415mm Locking nut x 8
15mm Screw x 16
I
J K L
Shelf support x 8Nail x 10Plastic support x 3
Foot x 1
M N
Door pad x 4Support cover x 8
(This screw is included in
the door hinge bag)

4
Assembly Instructions
Step 1
Attaching the middle
shelf panel
a:
b:
a: Insert Dowels into
the Middle left panel
and Middle right panel
.
A
3
4
Use Screws to fix the
Middle left panel and
Middle right panel onto
the Middle shelf panel
.
B
3
4
9
Step 2
a: Screw Locking pins
into the Top panel .
D
1
Attaching top panel
Note:
Insert Locking pins
as far as shown.
Do not over tighten.
b: Carefully locate the
Top panel onto the
unit.
1
Insert 4 Locking nuts
into the unit.
G
Use a screwdriver to turn
Locking nuts clockwise
to lock.
G
A
A
B
B
B
B
D
G
G
G
D
D
D
D
9
1
1
3
4
3
4
D
D
D
D
G
Unfinished back edge

Assembly Instructions
Step 3
5
b:
a:
c:
Attaching left and right
panels
the Door hinges ‘back
plates’ onto the Right panel
and Left panel .
a: Use Screws to fix
H
F
6 5
b: Carefully locate the
Right panel and Left
panel onto the unit.
6
5
Insert 4 Locking nuts
into the unit.
G
Use a screwdriver to turn
Locking nuts clockwise
to lock.
G
c: Use Screws to fix
the Door supports
onto the Top panel .
C
14
1
G
C
6
6
5
1
1
G
C
C
C
F
H
H
F
G
14
14
H
H
F
F
5
F
H
F
H
14
Finished front surface

6
Assembly Instructions
Step 4
a:
b: Insert Dowels into
Right side support and
Left side support .
13
12
b:
A
c:
Attaching small back
panels
Slide small back panels
into the unit.
16
Step 5
a: Use Screws to fix
Plastic supports onto
the Front panel .
Attaching bottom panel
J
E
11
c: Carefully locate the
Right side support and
Left side support onto
the Front panel .
13
12
11
Continued on next page.
E
E
E
J
J
J
A
16
16
E
J
11
11
13
12
13
A
12
Finished
front surface
Unfinished
back surface
Finished front surface

Assembly Instructions
7
d:
Step - continued5
e:
f:
f: Use Screws to fix
the Bottom panel
onto the unit.
B
2
e: Use Screws to fix
Front panel onto the
Bottom panel .
11
2
E
Use Screws to fix Foot
onto the Bottom panel
.
E
I
2
d: Use Screws to fix
the Bottom panel onto
the Right side support
and Left side support .
B
13
12
2
E
B
BB
B
B
B
E
4
3
2
5
6
E
E
I
B
B
B
B
2
13
12
11
2
I
E
E

8
Assembly Instructions
Step 7
Step 6
Attach large back panel
using nails .
K
15
Fixing large back panel
Important:
The unit MUST
be ‘square’ when
back is attached.
Attaching shelf panels
Warning:
The unit is heavy.
Lift with care.
With help, carefully stand
the unit upright.
a: Slide Support covers
onto Shelf supports .
Insert Shelf supports
(Support covers are
included) into the unit.
Ensure they are well fitted
before inserting the
Shelves.
M
M
L
L
Note:
Set the shelf
supports to the desired
height.
b: Slide Shelf panels
into the unit.
10
b:
a:
15
K
M L
+
M L
+
M L
10
10
Unfinished back surface

Assembly Instructions
Step 8
9
Attaching hinges to
doors
Fix 4 Door hinges to
Left door panel and
Right door panel using
Screws .
7
8
H
F
Hanging doors
Step 9
a: With help, slot Door
hinges onto ‘hinge
plates’.
H
b: Tighten screw shown
to lock hinges in position.
See ‘
Hinge adjustment ’
in step 10 if the doors
need adjusting.
Repeat
a and b for
opposite door.
Carefully stick the Door
pads onto the Left door
panel and Right door
panel .
Tear off the protective
backing from the Door
Pads .
N
N
8
7
FNN
NN
F
H
H
H
H
7
8
8
F
a: b:
H
H
7
F
H
FN