Argos Home Baltimore 855/4819 User manual

Spare Parts
Visit: www.argos-support.co.uk
Email: [email protected]
Call: 0370 112 1928
Customer Support
Call: 0345 640 2020
Baltimore
Issue 4 - 13/01/20
855/4819 765/9557

Safety
Important - Please read these instructions fully before starting assembly
Care Advice
• Check you have all the
components and tools listed on
relevant pages.
• Remove all fittings from the
specified plastic bag and
separate them into their groups.
• Parts of the assembly will be
easier with 2 people.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand or put weight on
the product, this could cause
damage.
• WARNING: To prevent
possible overbalancing this unit
must be secured to a wall using
the 2 overbalance protector kits
supplied.
• A unit that is allowed to topple
can cause serious or fatal injury.
In addition to wall fixing the unit,
place heavy items on the lower
shelves, do not put any heavy
objects on top of the unit and
never allow children to climb or
hang on drawers, doors or
shelves.
• Refer to guide after section 26
for wall fixing information.
• When applicable, remove any
protective film from the panels
before they are used.
• Assemble the item as close to
its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor (use opened
out unit carton).
• Assembly videos are
available throughout
these instructions by
scanning in the QR
codes.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
• Only clean with a damp cloth.
• Warning: This unit weighs
approximately 30kgs.
Please lift with care.
• Assembly to be carried out by
a competent adult only.
• During assembly children
should be kept away from the
product due to possible risk of
injury.
• Installation shall only be
carried out exactly according to
the manufacturer’s instructions -
otherwise a safety risk can
occur if incorrectly installed.
• Do not use this item if any
components are missing or
damaged.
• Regularly check all fastenings
to ensure they are properly
tightened.

Cabinet Panels
190 x 32.6cm
DF-00012372
290 x 32.6cm
DF-00012373
789.6 x 32.8cm
DF-00012371
883.4 x 31.8cm
DF-00012378
383.4 x 9.4cm
DF-00012374
483.4 x 9.4cm x3
DF-00012375
583.4 x 7.6cm
DF-00017888
683.4 x 7.4cm
DF-00012376
983.4 x 31.4cm x2
DF-00012379
11 31.6 x 19.8cm x2
DF-00012382
10 86 x 24.6cm
X860-246
12 26.2 x 19.2cm x3
DF-00012377
13 29 x 16.5cm x3
W290-165LH
14 29 x 16.5cm x3
W290-165RH
16 23.6 x 16.5cm x3
W236-165
15 24.7 x 28.7cm x3
T247-287
Drawer Panels

Fittings Use these drawings to
correctly identify the fittings
F171GY F461 F639
Bag 1
Kx 6 Lx 12 Mx 3 Nx 6
Bag 2
A
F901
F22
F73
F74
Ax 18 Cx 20
F910
Dx 6
Fx 12
F91
Jx 4 Gx 6 H
F3
F72
Ex 2
F51
Ix 25
A
F901
Ax 6
F180
x 8
Bx 18
F900

Fittings
F474
F220
F1004
Ox 2 Px 3
Qx 6
Tools
Only used for
drilling walls

1
Fx 4
Qx 2
2
1
A B
A B
Bag 1
A
F901
F22
F73
F74
Ax 18 Cx 20
F910
Dx 6
Fx 12
F91
Jx 4 Gx 6
F72
Ex 2
F51
Ix 25
2nd hole
2nd hole
www.youtube.com/watch?v=yG4xJJeSg
Fitting Ball Bearing Runners
Hx 8
Bx 18
F900

2
1
2
Cx 4
2
1
3
2
1
4
Ax 14
Bx 4

Finished
front edge
5
Fx 8
Qx 4
Finished
front edge
A B
A B
2nd hole
Turn the
panels
over
11
11
Finished
front edge
Finished
front edge
11
11
www.youtube.com/watch?v=yG4xJJeSg
Fitting Ball Bearing Runners

Finished
front edge
Finished
front edge
Finished
front edge
6
Cx 2 Bx 2
7
Dx 2
11
11
3
8
Cx 4 Bx 4
3
4
4

Finished
front edge
9
11
Dx 4
4
4
2
10
2
x 3

Finished
front edge
13
12
Cx 4 Bx 4
14
Cx 2
8
8
6
x 2

15
6
5
16
Cx 4 Bx 4
4

17
18
4
5
x 2
1
x 7

19
20
Ax 4 Ox 2
Only use 1 Screw
to fit each Bracket
Finished
front edge
Finished
front edge
7
7

21
22
Ex 2
7
3
3
x 2

=
24
Ix 25
23
www.youtube.com/watch?v=FeaI6541z7o
Squaring up a Chest and tting the Back Panel
A = B Make sure measurement A and B are
the same before attaching part 10
A
B
A
B
10
10

25
Jx 4
26
Ox 2
Slide the Brackets
against the wall. Fit the
2nd screw supplied with
the Brackets into the
underside of the Top
panel.
Mark the slot at the
back of the Brackets for
drilling into the wall.
Wall fixings are not
supplied as they will
need to suit the wall
type.
Note: Take care when
drilling the wall that
you do not drill into
any pipes, wires etc.
If in doubt, consult an
expert.
WARNING!
In order to prevent overturning
this product must be used with the
2 wall attachment devices provided
See the next section for a guide
to wall mounting and fixings

Important note:
Important: When drilling into walls always
check that there are no hidden wires or pipes etc.
If plastic wall plugs
are supplied with your
product:
- these are only suitable for
use in masonry walls.
If you are in any doubt about
the correct wall plugs for
your wall, seek professional
advice.
Failure of the product due to
using incorrect fixings is the
responsibility of the installer.
Make sure that the screws and wall plugs being used
are suitable for supporting your unit. Consult a qualified
tradesperson if you are unsure.
Hints:
1: General rule: Always use a larger screw and wall plug
if you are not sure.
2: Ensure you use the recommended drill bit to match the wall
plug and hole size.
3: Ensure you drill the hole horizontally, do not force the drill or
enlarge the hole.
4: Take extra care when drilling high walls, ceilings and ceramic
tiles. Ensure wall plugs are inserted beyond the thickness of
the ceramic tiles to avoid the tiles splitting or cracking.
5: Ensure wall plugs are well fitted and are a tight fit in the
drilled hole.
Types of walls You can use one of the following types of wall plug if your
walls are made of brick, breeze block, concrete, stone or wood.
Generally aerated blocks should not
be used to support heavy loads, use
a specialist fitting in this case. For light
loads, general purpose wall plugs can
be used.
For use with plasterboard partitions or
hollow wooden doors.
For use with walls stuck with
plasterboard. The hammer fixing allows
it to be fixed to the wall rather than the
plasterboard. Always check the fixing
is secure to the retaining wall.
For use when attaching light loads on
to plasterboard partitions.
For use when fitting or supporting
heavy loads such as shelving, wall
cabinets and coat racks.
For use with heavier loads such as TV
& HiFi speakers and satelite dishes etc.
No.1 “General Purpose” wall plug No.3 “Cavity Fixing” wall plug No.5 “Hammer Fixing” wall plug
No.2 “Plasterboard” wall plug
No.4 “Cavity Fixing-Heavy Duty”
wall plug
No.6 “Shield Anchor” wall plug
Heavy loads
A Guide to Wall Mounting & Fixings
Care &
Maintenance
Safety: Always check the fitting
and location to ensure your safety
in and around the home.
Fitting: From time to time check
the fitting to ensure the wall plugs
or screws do not become loose.

28
x 3
Drawer Assembly
27
F171GY F461 F639
Kx 6 Lx 12 Mx 3 Nx 6
Bag 2
F3
A
F901
Ax 6
Kx 6
Ax 6
www.youtube.com/watch?v=InNBV_uuMmo
Drawer Assembly
12
13 14

29
30
31
Lx 6
15
12
13
14
16