Argos Hygena 600/5968 User manual

Width - 90cm
Depth - 90cm
Height - 75cm
Important– Please read these instructions fully before starting assembly
Customer Helpline: 08456 400800
Assembly Instructions -Please keep for future reference
Dimensions
Issu 1 - 9/02/10
Hygena Square Table
If you need help or have damaged or missing parts, call the
656/2731
656/2731
600/5968
600/5944

Safety and Care Advice
Important– Please read these instructions fullybefore starting assembly
Care and maintenance
1
• Check you have all the
components and tools listed on
page 2
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand or put weight on
the product during assembly,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.

2
Components- Parts
Please checkyou have all the panels listed below
Components- Fittings
If you have damaged or missing components,
call the
Customer Helpline: 08456 400800
Please checkyou have all the panels listed below
Note :The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
Bolt x 8
B
Spring washer x 8
C
D
Washer x 8
Allen key x 1
A
Table top x 1
1
2Leg x 4

3
AssemblyInstructions
1
b:
Step 1
Carefully place table top
upside down being careful
as to not scratch the table
top surface (Leaving the
product within its
cardboard packaging will
assist you in being able
to do this)
Now attach the legs
(x4) to each of the
corners, by first applying
the bolt followed by
Spring washer and
Washer through
corners blocks to the
holes on each then lastly
tighten using the
Allen key .
Tighten all 8 bolts
securely.
A
C
a:
B
2
D
b:
2 people are required
for this next stage.
Please now turn the table
180 degrees and place on
all four of its legs in your
desired location.
If you need help or have damaged or missing parts, call the Customer Helpline: 0845 6400800
A
B
C
2
a: