Argos salisbury 338/4400 User manual

338/4400 356/8604 360/9123 365/4666
359/8045 355/3516 333/6348 345/8673
331/4047 359/6449 331/4951 357/5752
455/2121 498/3154 455/1081 687/2744
711/9279 715/9662 855/4912 850/7749
854/2395 854/8818
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6400800
instructions for use - please keep for future reference
important - please read these instructions fully before using the product
salisbury
Issue 3 - 23-05-2018

Safety and Care Advice
important - Please read these instructions fully before starting assembly
• Assemble on a soft level surface to avoid damaging the sofa or your floor.
• Parts of the assembly will be easier with 2 people.
With clean movements bring
the back cushions of the chair
back to their original shape.
Spread the leather evenly across
the seat cushions with the palms
of your hands
Give the arm pads a good plump
and then straighten them as
shown.
Before your furniture leaves the factory, it is given a final inspection prior to secure wrapping for
distribution. Due to tight and secure wrapping to minimise movement during transit, when unwrapped, the
chair may appear a little "distressed". This is entirely normal, and the illustrations below show how to
rectify this in 3 easy steps:
Step 1
Step 2
• Make sure you have enough space to work and layout the sofa.
• Assemble the sofa as close to its final position (in the same room) as possible.
Step 3
• Remove the protective cellophane wrapping the sofa. Do not use sharp tools that may damage the sofa
covering.
• Feet and accessories can be found by opening the zip underneath the sofa. To access this zip spread
the cellophane sheet on the floor, lower the sofa so that the rear back panel rests against the floor.
Remove package containing the feet and accessories, then install the feet.
• Once feet are securely attached return the sofa to an upright position. To do this the sofa must be lifted
and turned. Avoid using the feet as a lever as doing this may lead to damage.
• Dispose of all packaging carefully and responsibly.
Issue 3 - 23-05-2018

Ref Quantity
4
M8 x 80
M5 x 70
Ref
Fixtures and Fittings supplied (Not Actual Size)
Dimensions (mm)
Visual
Quantity
4
Components, Fixtures and Fittings
Components supplied (not actual size)
1
4
Visual
1
2
A
B
Issue 3 - 23-05-2018

Gently turn the product
onto its feet.
Assembly is complete.
Assembly Instructions
Step 1
Line the feet with
the pre-drilled holes.
Step 2
Using the Hex Key
Supplied gently screw the
bolt clockwise to
engage thread and
tighten.
Step 3
1
A
A
1
Issue 3 - 23-05-2018

• Loose Threads should be cut carefully not pulled as this
may unravel the stitching.
• Biro:- Remove any Biro marks immediately as the ink will eat
into the leather.
• Beware of sharp or hot objects :- Buckles, keys, toys and
jewellery can easily snag on the fabric and cause tears and
pulls. Hot objects, such as heat from mugs or cups can
permanently disfigure upholstery.
Safety and Care Advice
maintenance
• Keep a minimum distance of 20-30 cm between your
furniture and any source of heat i.e. fires or radiators.
• Avoid exposing the sofa to direct sunlight or to powerful
lamps to as this may result in the leather fading. Protect it by
drawing curtains or blinds.
• Vacuum or use a soft brush weekly as accumulated dust and
dirt will wear and dull the material.
• Zips are fitted to assist in the ease of manufacture and do
not necessarily mean the cover is removable for washing or
cleaning.
 Do not move the sofa by pushing or pulling it by the arms on
smooth or rough surfaces. If the sofa has to be moved the
correct way to do so, is by lifting it from the base with two
persons. Improper handling may lead to the feet or stitching to
be damaged.
 Excessive Force :- Use your sofa responsibly. Do not jump
on the sofa and avoid sitting on the edges of cushions and
arms as this may cause distortion and permanent damage.
Pets sleeping / lying on the furniture, as their natural body
oils/hair/saliva can cause damage to the leather finish.
 Especially do not allow domestic pets to claw or climb on the
sofa, they have sharp claws which can scratch the leather.
Their saliva is very harmful to leather as are their body fluids
and oils.
 The product is designed for interior use only. When the time
comes to discard it, do not dispose of the sofa improperly but
make use of public waste disposal systems.
 Avoid
Wearing dark clothing especially denim jeans.
Leaving newspapers lying on the furniture.
Both of the above can result in dye/print being ground into the
fabric and can result in cream/pale finishes going grey in
colour.
Restrain children from climbing or jumping on the furniture,
especially in shoes.
Issue 3 - 23-05-2018

- Lift up the part arm unit.
-Fit the metal joining plates of part
in to part metal plates and lower
the part until the metal plates are
joined.
- Press the part down,make sure
that the height of the seats is the same
and that there is no gap between
part and part
- Repeat the above steps with the
other arm unit.
Assembly Instructions
Corner
Step 1
Step 2
Step 3
3
1
1
3
1
1
3
1
1
2
3
2
Issue 3 - 23-05-2018

1. Remove the seat cushions and place in a safe area.
User Instructions
Important -
Please read these user instructions fully before using the
sofabed, a few minutes spent doing this will allow you to fully understand
all the functions of this product.
Opening of the Sofabed
• Do not sit or stand on the head of the bedspring.
2. Raise the bedspring by gripping the centre handle and pulling
outwards. (Fig. A)
3. Grip the first supporting bar at the centre of the bar,
raise and accompany the bar until it touches the floor.
(Fig. B)
4. Repeat the operation for the second supporting bar.
(Fig. C)
Closing of the Sofabed
In order to close the sofabed repeat the operations above
in reverse order, always holding the support bar in the
middle.
Warning :
• Do not jump on the bedspring.
• Avoid sitting on the edge at the front of the bedspring.
• Remove bed sheets and blankets before closing the
bedspring.
• Operating the device improperly can cause permanent
damages to the mechanism and cause the torsion bars
and lever to bend.
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6400800
• Before using the sofabed, it is necessary to cut the safety
tab that restrains the bed mechanism.
• Beware of entrapment. Keep hands and fingers clear of
mechanism when operating the controls.
•Ensure that children or pets are not playing or lying in the way
when the mechanism is operated.
• Prevent children from playing on the furniture or with the
controls.
• Do not use solvents to clean the metal parts of the
sofabed : a dry cloth is sufficient.
Issue 3 - 23-05-2018

BEFORE USING ANY CLEANING AIDS, PLEASE READ THE INSTRUCTIONS CAREFULLY
AND TEST ON A HIDDEN AREA FIRST.
EMERGENCY CLEANING
If a major spill has occurred requiring immediate attention, do the following:
• Use a mild unscented soap with distilled water.
• Dab the spot carefully with the solution.
• Avoid soaking the leather.
Accidental spillage
Where possible:
• Always tip liquid spillages from the surface of the fabric.
• Blot excess liquid with tissues or toilet roll.
• Allow to air dry.
Safety and Care Advice
Cleaning Information Leather
Thorough Cleaning
Thorough Cleaning is recommended at least every 6 months to remove the gradual accumulation of body
oils, perspiration, skin acids and general soiling (this includes the oils/hair from pets).
Use a specialist cleaning kit, taking into account any advice supplied by the manufacturer.
• If possible, treat the stain from the wrong side of the fabric and never use a hard scrubbing action.
Water based stains
• If necessary, sponge the area but do not over wet as water can shrink fabrics or their backing fibres.
IF UNSURE SEEK THE ADVICE OF A PROFESSIONAL
DO NOT USE
• Harsh chemicals like acetone (nail polish remover), bleach, house-hold cleaners or stain removers.
• Coloured shoe polish as it will run onto clothes.
• Spray polishes, saddle soaps, waxes, "Hide foods".
These create a sticky surface attracting dirt and causing irreversible damage, which can over time, build up
layers which will eventually crack, damaging the leather underneath.
Cleaning Information Fitted Covers
• Use a specialist upholstery cleaner/shampoo. If a specialist cleaner is not available a very weak (2%)
solution of washing powder can be used in hot or cold water.
• Remember to damp a complete panel to avoid marking.
• Always remove stains in the direction of the pile, if any. BE GENTLE - do not rub or scrub as this will only
spreads the stain and can damage fabrics.
General dirt and stains
• Use a clean damp cloth (not wet) and if necessary use a gentle cleaning aid.
• Never use hot water as this can set the stain into the fabric.
• Do not use detergents as these can cause colour loss and leave sticky residues.
Follow cleaning symbol guidleines as shown below.
Grease or oil based stains
• Use a propriety spot cleaner working from the edge of the stain inward to avoid spreading.
• Use the mixture sparingly.
• Dab gently from the outer edge, inward.
• Dab out shampoo afterwards using warm water.
DO NOT SOAK
Cleaners are available from most supermarkets and hardware stores.
BEFORE USING ANY CLEANING AIDS, PLEASE READ THE INSTRUCTIONS CAREFULLY AND TEST ON A
HIDDEN AREA FIRST
Issue 3 - 23-05-2018

489 - 499 Avebury Boulevard
Central Milton Keynes
MK9 2NW
Safety and Care Advice
Attention :
 Natural leather is a noble and resistant material,
which becomes more valuable over time. Its
transpiration properties make it warm in winter and
cool in the summer, and its flexibility allows it to
mould perfectly to the body's shape. Characteristics
such as healed scars, wrinkles, insect bites, breaks,
veining and variations in grain and colour are
natural features of hides of leather that give them
their value and natural character. These
characteristics should not be viewed as defects, but
as confirmation that you have purchased genuine
leather and not an imitation. These markings will
depend on the grade of leather you have selected.
 During the first three months of use the
polyurethane foam padding used in the seats tends
to become softer and then finally stabilizes itself. This
process is absolutely natural as when pressure is
applied on the seating the micro-cells that comprise
the polyurethane break down. This process is
perfectly normal for this kind of material and
produces a slight softening effect. As above, it is
absolutely normal that the softness of a seat / back
padding is found to be different from the one
adjacent, depending on its usage. Light creases may
form on the covering following the abovementioned
natural setting of the padding, which are to be
considered absolutely normal and depend on the
settling of the leather.
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6400800
product guarantee
This product is guaranteed against manufacturing defects for a period of up to 5 years*.
Terms and conditions apply. Please refer to argos.co.uk for full details.
Produced for Heart of House
Country of Origin - Romania
This does not cover the product where the fault is due to misuse, abuse, use in contravention of the
instructions, or where the product has been the subject of unauthorised modifications or alterations, or has
been the subject of commercial use.
In the event of a problem with the product within the guarantee period please call 0345 601 2895.
Please retain your receipt and order number as proof of purchase.
Your statutory rights remain unaffected.
*5 years for the frame, armrests, springs and mechanism.
2 years for the cover fabric.
Issue 3 - 23-05-2018