Argos Perth 423/8029 User manual

Perth Dining Table
Assembly Instructions - Please keep for future reference
Issue 1 - 10/04/15
Length - 90cm
Width - 90cm
Height - 76cm
Dimensions
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 640 0800
423/8029
392/9652

1
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product, this
could cause damage.
• Assemble the item as close to
its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Unit weight: 10.9 kgs.
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Care and maintenance
Handy Hints
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• Do not stand on the product.
• Always lift the product when
moving it around. Never drag.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the
bolts.
• Regularly check and ensure
that all bolts and fittings are
tightened properly.

2
Components - Parts
Components - Fittings
Please check you have all the parts listed below
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
Table top
(90 x 90 x 1.8cm)
1
Upper leg
(86 x 74 x 3cm)
2Lower leg
(86 x 74 x 3cm)
3
M6 x 12mm Bolt x 12 Mounting Plate x 1
A
Allen Key x 1
CB
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
If you have damaged or missing components, call the
Customer Helpline: Argos = 0345 640 0800

3
Assembly Instructions
Step 1
Assembling legs
Place the table top
upside down on a flat
protected surface.
a: Position the upper leg
and lower leg on
the table top as shown.
b: Fix the legs to the
table top using bolts
and tighten using allen
key .
1
2 3
A
C
a: b:
1
2
3
A
A
A
A
A
A
A
1
3
2
3
A
A

Securing the legs
Position the mounting
plate on the center of
the legs and as
shown then fix using
bolts . Tighten bolts
using allen key .
Carefully turn over the
table.
Note: At least
two people are
required to lift
this unit.
Assembly Instructions
Step 3
Step 2
4
2 3
Assembly is complete.
2
AA
A
AB
B
A
C
23
3
A
B
A
AA
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 640 0800